667340
49
Zoom out
Zoom in
Previous page
1/544
Next page
0478 111 9917 F - EN
15
DEEN
FR
NLITESPTNOSV
DA
PLSL
HU
HR
CS
Installing the mowing
blade:
37= Install mowing blade with
the curved edges poin-
ting upwards.
40= Guide the guide pin of
41= blade mount through the
bores provided on the
mowing blade.
For installation, use a
36= wooden block to coun-
terhold the
37= mowing blade (see
illus.).
38= Tighten the blade faste-
ning screw with
51= clamping washer,
53= washer and
50= lock washer. Observe
the specified torque of
60 - 65 Nm.
Tighten the three bolts
of the
39= support to a torque of
20 - 25 Nm.
CAUTION
Risk of injury.
The specified tightening
torque of 60 - 65 Nm for
the blade fastening screw
must be observed.
The specified tightening
torque of 20 - 25 Nm for
the three bolts for the sup-
port must also be obser-
ved.
Secure blade fastening
screw 38 with Loctite 243
and replace lock washer 50
each time the blade is
installed.
NOTE
Note the installation se-
quence of the parts and the
installation direction.
Sharpen blade evenly to
prevent imbalance.
A cutting angle of 30° must
be observed.
Check blade for damage
before installing. The blade
must be replaced if notches
or cracks are identified, if
the blades are worn back
by 5 mm, or if the blade is
thinner than 2 mm at any
point (wear limits).
Lubricating/greasing
Maintenance interval:
At least once a year or as
needed
- lubricate Bowden cables,
- lubricate free-running
wheels,
- grease cutting height ad-
justment pin,
- grease drive chain,
WARNING: Then securely
attach the protective hou-
sing again,
- lubricate all joints (chas-
sis, tension roller, etc.),
- grease the pivot pin of the
front wheel.
19
... Oil
... Grease
Combustion engine
Maintenance interval:
See engine instruction ma-
nual
Observe the operating and
maintenance instructions con-
tained in the engine instruc-
tion manual provided.
To achieve a long service life
it is always particularly impor-
tant to maintain a sufficient
level of oil and to change the
oil regularly, to clean the preli-
minary filter and air filter regu-
larly, to clean the entry
opening of the air intake
nozzle as well as to ensure
there are no blockages in the
pipe and the air filter cover is
properly attached. The coo-
ling ribs must always be kept
clean to ensure that the en-
gine is adequately cooled.
49


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viking MB 6RV at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viking MB 6RV in the language / languages: All languages as an attachment in your email.

The manual is 35,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Viking MB 6RV

Viking MB 6RV User Manual - German - 34 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info