667227
39
Zoom out
Zoom in
Previous page
1/352
Next page
37
DEFRNLITESPTNOSVFIDAPLHUHRLV EN
0478 111 9924 C - EN
7.1 General
Place the machine on level and firm
ground when performing all the
operations described.
7.2 Assembling the handlebar
(MB 4 R, MB 4 RT)
Fit the protective sleeves (E)
onto the upper handlebar (1) with the
long side facing inwards.
Hold the upper handlebar (1) on the
lower handlebar (2) and insert the
screws (C) through the bores (3) from
the inside outwards.
Screw in the quick-clamping device (D)
at the screws (C) (it should project by
about one screw thread turn) and fold
upwards.
Check correct assembly:
The quick-clamping devices (D) must
be sufficiently tightened so that they are
pressed tightly against the handlebar
and the upper handlebar is firmly
connected to the lower handlebar.
If the handlebar is not firmly installed or
the quick-clamping devices are not
correctly located, fold open the quick
clamping devices and adjust them to
the correct position by screwing out and
back in again.
7.3 Assembling the handlebar
(MB 4 RTP)
Fit the protective sleeves (I) onto
the upper handlebar (1) with the long
side facing inwards.
Hold the upper handlebar (1) on the
lower handlebar (2) and insert the
screws (F) through the bores (3) from
the outside inwards. Fit the retaining
washers (G) and lock nuts (H) and
tighten to 22 - 28 Nm.
Check correct assembly:
The upper handlebar must be firmly
fastened to the lower handlebar.
7.4 Installing the cable clip
Fasten motorstop cable (1) to the
left upper handlebar using cable
clip (B).
MB 4 RT, MB 4 RTP:
Fasten self-propulsion cable (2) to the
right upper handlebar using cable clip
(B).
Observe the following distances between
the lower edge of the boot/panel and the
cable clip:
MB 4 R, MB 4 RT: 42 - 44 cm
MB 4 RTP: 37 - 39 cm
7.5 Attaching the cable (MB 4 RT,
MB 4 RTP)
Press the self-propulsion
cable (1) into the guide (2) along the
detent segment.
7.6 Fuel and engine oil
Fuel
Use only fresh, environmentally
friendly, good quality fuel:
Unleaded petrol
Please consult the engine
instruction manual for precise details on
the fuel quality/octane rating.
Engine oil
Use only biodegradable engine
oils. VIKING recommends the
use of the following engine oils:
VIKING SAE 30
VIKING 10W-30
Please consult the engine instruction
manual for the oil capacity.
Filling the fuel tank
Unscrew the tank cap (1).
Insert the funnel (2).
7. Preparing the machine for
operation
Risk of injury!
Observe the safety instructions in
the section "For your safety" (Ö 4.).
3
4
5
6
7
Risk of injury!
Observe the safety instructions in
the "For your safety" section.
(Ö 4.2)
Check the oil filling level at regular
intervals (see engine instruction
manual).
Use a suitably dimensioned funnel
when filling the tank with fuel, in
order to prevent the fuel from
spilling.
8
9
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viking MB 4RT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viking MB 4RT in the language / languages: All languages as an attachment in your email.

The manual is 21,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info