667285
6
Zoom out
Zoom in
Previous page
1/8
Next page
Technical Information 15.01
- Page 6 -
- Engine will not start - Motorstop lever is not pressed
- No fuel in tank; fuel line blocked
- Inferior, dirty or old fuel in tank
- Dirty air filter
- Spark plug connector disconnected from
spark plug; ignition lead incorrectly
fastened to connector
- Spark plug dirty or damaged;
incorrect electrode gap
- Engine is flooded due to several starting
attempts
- Mower housing is blocked
- Press motorstop lever to handlebar
- Top up fuel, clean fuel line
- Always use fresh, good quality fuel,
normal unleaded petrol; clean
carburettor
- Clean air filter (see engine
instruction manual)
- Connect spark plug connector;
check connection between ignition
lead and connector
- Clean or replace spark plug; adjust
electrode gap (see engine
instruction manual)
- Remove spark plug and dry; pull
starter cable repeatedly with the
spark plug removed (throttle lever in
STOP position)
- Clean mower housing (disconnect
spark plug connector before
cleaning)
- Starting problems or
deteriorating engine
performance
- Mowing grass which is too long or too
wet
- Mower housing is blocked
- Dirty air filter
- Dirty spark plug
- Mowing blade is blunt or worn
- Water in fuel tank and carburettor;
carburettor blocked
- Work at appropriate cutting height
and mowing speed for mowing
conditions
- Clean mower housing (disconnect
spark plug connector before
cleaning)
- Clean air filter (see engine
instruction manual)
- Clean spark plug
- Re-sharpen or replace mowing
blade
- Empty fuel tank, clean fuel line and
carburettor
- No drive when clutch lever is
actuated
- Drive cable incorrectly adjusted - Re-adjust drive cable
(see instruction manual)
- Engine overheating - Cooling fins are dirty
- Oil level in engine too low
- Clean cooling fins
- Top up engine oil (see "Fuel and
engine oil" in instruction manual)
- Excessive vibration during
operation
- Uneven cut, lawn turns yellow
- Ejection chute blocked
- Blade bolt is loose.
- Engine mounting is loose
- Blade imbalance due to incorrect
re-sharpening or to deformation
- Mowing blade is blunt or worn
- The rate of feed is too high in relation to
the cutting height
- Mowing blade is worn
- Mowing grass which is too long or too wet
- Tighten blade bolt
- Tighten engine fastening bolts
- Re-sharpen (balance) or replace
blade
- Re-sharpen or replace mowing
blade
- Reduce the advance speed and/or
select the proper cutting height
- Replace the mowing blade
- Work at appropriate cutting height
and mowing speed for mowing
conditions
6. Troubleshooting
Fault Possible cause Remedy
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viking MB 410 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viking MB 410 in the language / languages: English as an attachment in your email.

The manual is 0,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info