667342
34
Zoom out
Zoom in
Previous page
1/502
Next page
0478 670 9903 C - EN
32
and replaced by a technician if necessary
(VIKING recommends VIKING specialist
dealers).
Ensure that all nuts, pins and screws are
securely tightened, so that the machine is
in a safe operating condition at all times.
Check the complete machine and the
grass catcher box (accessory – not
included in standard equipment) for wear
or damage on a regular basis, particularly
before extended periods when the
machine is not in use (e.g. over winter).
For safety reasons, worn or damaged
parts must be replaced immediately to
ensure that the machine is always in a safe
operating condition.
Replace damaged mufflers and guard
plates. The scarifier must not be used with
a defective muffler.
Never alter the basic setting of the engine
or run at excessive engine speeds.
Components or guards that are removed
for maintenance operations must be
properly reinstalled immediately.
4.8 Storage for prolonged periods
without operation
Store the cooled machine in a dry and
locked place.
Ensure that the machine is protected from
unauthorised use (e.g. by children).
Thoroughly clean the machine before
storage (e.g. winter break).
Store the machine in good operational
condition.
4.9 Disposal
Ensure that old machines and
consumables (engine oil and fuel) are
properly disposed of. Render the machine
unusable prior to disposal. To prevent
accidents, render the engine unusable
prior to disposal. In particular, remove the
ignition lead, empty the fuel tank and drain
the engine oil.
Risk of injury caused by the scarifying
unit!
Always store an old machine in a safe
place prior to scrapping. Make sure that
the machine and the blades are kept out of
the reach of children.
5. Description of symbols
Caution!
Read the instruction man-
ual before initial use.
Risk of injury!
Keep other persons out of
the danger area.
Risk of injury!
Caution: sharp work tools. –
Take care not to cut your fin-
gers or toes. – The blades
continue to rotate after the
engine has been switched
off. – Detach the spark plug
socket before performing
maintenance work.
Risk of injury!
Caution: cutting tools run
on.
Wear hearing protection.
Wear safety glasses.
Start the engine.
Stop the engine.
Scarifying unit in transport
position
Scarifying unit in operating
position
34


Need help? Post your question in this forum.

Forumrules
1

Forum

viking-lb-540

Reset search

  • Is there a drawing showing the removal and replacement of blades on a viking LB540.1 Submitted on 28-6-2021 at 18:11

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viking LB 540 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viking LB 540 in the language / languages: All languages as an attachment in your email.

The manual is 25,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info