652088

Viessmann 5242 Manual

7
Zoom out
Zoom in
Previous page
1/16
Next page
7
Decoder 5243: Einbau in Loks
mit NEM 651-Schnittstelle
Beachten Sie den Anschlussplan in Abb. 1.
►ÖffnenSiedieLokundentfernenSiedenBrü-
ckenstecker aus der Schnittstellenbuchse der
Lok.
►SteckenSiedenNEM651-SteckerdesDeco-
ders in die Schnittstellenbuchse der Lok.
AchtenSiebeiVerwendungvonDecodernmit
6-poligenSteckernnachNEM651darauf,dass
dieMarkierungenaufdemSteckerundder
Buchse nach dem Einbau übereinanderliegen.
KlebenSieinderNähebendlicheMetallteilemit
Isolierband ab. Decoder nicht in Isolierband ein-
wickeln,daesdieWärmeabfuhrbehindertundzu
thermischerÜberlastungführt.
Decoder 5242: Einbau in Loks
ohne NEM 651-Schnittstelle
ZumEinbauinLoksohneSchnittstellenbuchse
verwendenSiebittedenDecodermitAnschluss-
drähten(Art.Nr.5242).BeachtenSieunbedingt
dieBelegungderAnschlüsse(Tabelleunten)und
die Abbildung 1.
►ÖffnenSiedasGehäusederLokundlegenSie
dieStellefest,anderSiedenDecodereinbau-
en wollen.
►TrennenSiedieVerbindungendesMotorszu
denSchienenabnehmernbzw.beiLoksmit
elektronischemUmschalterdieVerbindungen
desUmschalterszumMotorundzudenSchie-
nenabnehmern.DerUmschalterwirdnicht
mehrbenötigt.
►LötenSiedievondenSchienenabnehmern
kommenden Anschlüsse an den Punkten X3
und X4 an.
►LötenSiedanndievomMotorkommenden
Anschlüsse an den Punkten X1 und X2 an.
Sollte die Fahrtrichtung der Lok im Analogbe-
trieb nicht mit der am Trafo eingestellten Fahrt-
richtungübereinstimmen,müssenSiedieAn-
schlüsse X1 und X2 austauschen.
Anschluss
connector
Farbe Funktion
Colour Function
Aux1(X5) weiß AusgangSpitzenlicht(max.100mA) white Outputfrontlight(max.100mA)
Aux2(X6) gelb AusgangSchlusslicht(max.100mA) yellow Outputrearlight(max.100mA)
COM(X7) blau gemeinsamerRückleiter blue Common return conductor
X 4 schwarz Schienenabnehmer links black Railcollectorleft
X 3 rot Schienenabnehmer rechts red Railcollectorright
X 2 grau Motorausgang(bis500mA) grey Motor(max.500mA)
X 1 orange Motorausgang(bis500mA) orange Motor(max.500mA)
Decoder 5243: Mounting into locos
with interface as per NEM 651
Followtheconnectiondiagramg.1.
►Openthelocoandremovethebridgeplate
fromtheinterfacesocketoftheloco.
►InserttheNEM651-connectorintotheinterface
socketofthelocomotive.
Notice,thatthemark(oftena“*”ora“+”)which
isoftenprintedonthecircuitboardtsthemark
on the decoder.
Insulateallmetalpartsclosetothedecoderbut
don’twrapthedecoderwithinsulationtapeto
avoidoverheating.Otherwisethedecodermay
bethermallyoverloaded.Ifnecessarryxthede-
coderwithadoublesidedadhesivepad.
Decoder 5242: Mounting into locos
without interface as per NEM 651
Formountingintolocoswithoutaninterface“651”
pleaseusethedecoder5242.Noticethetable
belowandgure1whichshowstheconnection
diagram.
►Openthelocomotivehousing.Locatetheposi-
tion for the decoder.
►Disconnectthemotorfromtherailcurrentcol-
lectororthechange-overswitchfromthemotor
andrailsifyouhavealocomotivewithelectron-
icchange-overswitch.Thechange-overswitch
isnolongernecessary,youcanremoveit.
►SoldertheconnectiontotheslideratpointX3,
andtheconnectiontothehousingtopointX4.
Thesetwoconnectionscanbeexchangedwith-
outeffectingfunctionality.
►Nextsoldertheconnectionsfromthemotorto
thepointsX1andX2.Shouldthelocomotive´s
directionofmotioninanaloguemodenotmatch
thedirectionofmotionsetatthespeedcontrol
youhavetoswaptheconnectionstothepoints
X1andX2.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viessmann 5242 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viessmann 5242 in the language / languages: English, German as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info