785222

Victron Lynx Smart BMS 500 Manual

35
Zoom out
Zoom in
Previous page
1/40
Next page
BMS
Check BMS functionality by deliberately loosening a BMS cable
10.3.7. System in sleep or hibernate mode
This is indicated by the status LED off and the Bluetooth LED flashing every 3 seconds.
The Lynx Smart BMS goes into sleep or hibernation mode once the battery or a battery cell has been deeply discharged. The
Lynx Smart BMS will conserve as much power as possible, to not discharge the battery much further and will switch the Bluetooth
module and other non-essential internal circuits off.
Check the voltages of the connected batteries and if they are low, charge the batteries. As soon as the Lynx Smart BMS sees a
charge voltage it will automatically re-activate and close its contactor to allow for battery charging.
10.3.8. Battery communication error
This is indicated by the red LED flashing 2 times every 4 seconds or with the GX device BMS cable error. A battery
communication error occurs when the Lynx Smart BMS is not connected to the battery BMS communication cables, or if there is
an issue with the BMS cables. To remedy this error, check the following:
• Check if both battery cables are connected to the Lynx Smart BMS.
• In case of a multiple battery setup , check if all batteries are interconnected
• Check for loose connections, the male connector needs to screw “hand tight” into the female connector.
10.4. Battery monitor issues
10.4.1. Incomplete current reading
The negatives of all the loads and the charge sources in the system must be connected to the system minus side of the Lynx
Smart BMS.
If the negative of a load or a charge source is connected directly to the negative battery terminal or the “battery minus” side on the
Lynx Smart BMS, their current will not flow through the battery monitor and will be excluded from the overall current reading and
the state of charge reading.
The SmartShunt will display a higher state of charge than the actual state of charge of the battery.
Lynx Smart BMS
Page 32 Troubleshooting and Support
… 35 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Victron Lynx Smart BMS 500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Victron Lynx Smart BMS 500 in the language / languages: English as an attachment in your email.

The manual is 3.23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info