785457
12
Zoom out
Zoom in
Previous page
1/27
Next page
Last update: 2018-08-21 10:10 ccgx:start https://www.victronenergy.com/live/ccgx:start
https://www.victronenergy.com/live/ Printed on 2018-08-21 11:59
Complete details of IP requirements, as well as used port numbers will be found in the VRM FAQ -
ports and connections used by the CCGX.
1.6.6 Connecting both Ethernet and Wi-Fi (failover)
It is possible to connect the CCGX to both Ethernet and Wi-Fi. In this case, the CCGX will try to
determine which interface provides an active internet connection and then use that interface. When
both have an active internet connection, the Ethernet connection is used. The CCGX will automatically
check again for active internet connections when something changes on the interfaces.
1.6.7 Minimize internet traffic
In situations where internet traffic is expensive, for example a satellite uplink or with roaming
GSM/cellular charges, you may want to minimize the internet traffic. The steps to take are:
Disable auto-update
Do not enable remote support
Reduce the Logging interval to a very low frequency. Note that state changes (charging →
inverting, or bulk→float) and also alarms will cause extra messages to be sent
To find out how much data allowance you need to buy the best way is to let the system run for a
couple of days and monitor the internet RX and TX counters in your 3G or 4G router. Or even better,
some mobile companies will report the data used via a website.
The amount of data used is also very dependent on the system:
More products connected to the CCGX will generate more data.
A state change (from inverter to charger for example) will trigger a data transmission, so a
system with very frequent state changes will also tend to generate more data. This is especially
true in certain Hub-1 and Hub-2 systems.
Note that CCGX versions prior to v1.18 will check for software updates daily even when auto-update is
switched off. This was changed in v1.18. Disabling auto-update also disables the check - saving a lot
of data.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Victron Color Control GX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Victron Color Control GX in the language / languages: English as an attachment in your email.

The manual is 0.97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info