783524
14
Zoom out
Zoom in
Previous page
1/44
Next page
10
5 - Unpacking and Assembly
CAUTION: The Vibiemme Domobar Super espresso machines are quite heavy. The shipping weight is
around 70 pounds! We recommend getting assistance whenever the machine has to be moved or relocated.
The Vibiemme Domobar comes double-packed to protect it during
shipping. Remove the inner box from the outer, and then open the inner
box and carefully remove the machine. Standing the box up on a carpeted
surface or on a large, soft towel so that the machine has its backside down
makes it easier to slide it out of the box (as shown here, to the left).
CAUTION: The machine ships with the hot water valve closed
and the steam valve open DO NOT force the valves. Moderate pressure
is sufficient to open or close the valves. They do not have to be shut
tight, or “seated” like a home faucet to seal properly.
Slip off the large plastic bag and remove the end of the power cord
from the parts box. Slide the parts box sideways to remove it from its ship-
ping location.
Please inspect the machine upon unpacking to be sure it was not dam-
aged during shipping. Report any shipping damage immediately to the
shipper as well as to your reseller/retailer.
WARNING: There are times when a machine will dribble water during shipping. If you notice that
the machine arrives wet or dripping, remove the machine as described in this section, but wait 24 hours
to allow excess moisture to evaporate to alleviate any electrical danger or damage from short circuits. If
in doubt, open the case as described later in this manual to assist in the drying as well as to inspect for ac-
cumulated water in the machine.
You may notice that there is a rough area on the right side of the grouphead where the chrome is not quite as
smooth and shiny as the rest of the grouphead. This is from the production process and is not a defect.
Assembly is quite easy. Open the small box which was packed under the grouphead. In that box you will
find a small bag with four, round, chrome-steel feet. These screw into the bottom corners of the machine. These
are easier to install with the machine still on its back. If necessary,
tip the machine slightly to get the screw threads started for the two
bottom feet.
CAUTION: The feet must be installed. Do not use the ma-
chine without them. The air space under the machine is impor-
tant for proper operation and the life of the machine.
After the feet have been installed, stand the machine upright
and remove the five pieces of tape- three holding the top cup warmer
and two holding the drip tray cover.
Remove the cup warming tray and take off the protective plastic
wrap and the white, stick-on protective plastic on the tray itself. Clean an remaining adhesive or bits of plastic
from the warming tray with a cleaning product meant for stainless steel.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vibiemme Domobar Super at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vibiemme Domobar Super in the language / languages: English as an attachment in your email.

The manual is 4.39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info