815507

Vermont Castings Radiance Series Manual

41
Zoom out
Zoom in
Previous page
1/56
Next page
4141 3-90-30007498Vermont Castings • Radiance RADVT Installation Manual_R32 • 10/23
E. Gasket Replacement
The Radiance Gas Heater uses a ‘tadpole’ type gasket to seal
between the glass panel and the frame. In time, this gasket
can become brittle and compressed and should be replaced.
New gasket is available from your dealer.
Shut o󰀨 the gas supply and allow the stove to cool. Wear
safety goggles and a dust mask.
1. Remove the front, glass frame and glass panel, Figures
5.1 & 5.2. To remove the old gasket, use a razor blade
to separate the glass and gasket from the frame, and
to clean the glass of any remaining cement or bits of
gasket. Use a cold chisel if necessary.
2. Determine the correct length of gasket by laying it out
around the edge of the glass. Allow an extra 1 - 2" (25-
50mm). Mark the spot to be cut. Use a utility knife.
3. Starting on a long edge, remove about 6” of the
protective paper strip and apply the at adhesive face
of the gasket around the outside-facing edge of the
panel. Continue around the panel, applying about 6” at
a time and being careful to not stretch the material. Do
not overlap the gasket ends, Figure 5.3.
4. Apply a thin bead of high temperature silicone rubber
sealant along the inside corner of the glass frame, all
around the perimeter. Place the at gasketed side of
the glass panel back into the steel frame. Pinch the
rounded inside-facing gasket material to bulk it up.
5. Replace the glass frame and front panel as previously
described.
ST179
glass gasket detail
11/99
Figure 5.3 - Wrap the gasket material around the outside edge of the glass.
LG490
all logs
6/07
Figure 5.4 - Proper ame appearance
F. Inspect the Vent System Annually
Have the vent system inspected annually by a qualied
technician. Shut o󰀨 the main gas supply before inspecting
the system. Both the inner exhaust pipe and the outer
combustion supply pipe must be checked to conrm that
they are unblocked and in good condition.
G. Check the Gas Flame Regularly
To ensure that the stove is operating properly, check the
ames periodically to conrm they match Figure 5.4. The
ames will be blue during the rst 15-20 minutes of operation,
and will gradually turn to yellow after that.
Do not use your stove if the ame pattern di󰀨ers from that
shown here. Contact your Vermont Castings dealer or a
qualied technician for help.
DANGER
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this
appliance and must be installed.
… 41 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vermont Castings Radiance Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vermont Castings Radiance Series in the language / languages: English as an attachment in your email.

The manual is 6.69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Vermont Castings Radiance Series

Vermont Castings Radiance Series User Manual - French - 46 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info