815506
19
Zoom out
Zoom in
Previous page
1/30
Next page
19 04/237102-803E
Clean all the ngerprints and oils from plated surfaces
BEFORE ringtheapplianceforthersttime.Ifnotcleaned
properly before lighting your rst re, the oils can cause
permanent markings on the plating.
Afterthe plating is cured, theoilswill not a󰀨ect the nish
andlittlemaintenanceisrequired.Wipecleanasneeded.
6. Inspect Firebrick
• Frequency: After each ash removal
• By: Homeowner
Replacetherebrickiftheybecomecrumblyand/orifthere
isa1/4inch(6.35mm)gapbetweenthebricks.
The rebox is lined with rebrick, which has exceptional
insulatingproperties.Donotuseagrate;simplybuildareon
thereboxoor.Donotoperateappliancewithoutrebrick.
1. After the coals have completely cooled, remove all old
brickandashfromunitandvacuumrebox.
2. Remove new brick set from box and lay out to the
diagram shown in the instructions that come with the
brick set or refer to the diagram on the service parts list
at the end of this manual.
3. Lay bottom bricks in unit.
4. Installrearbricksonthetopofthebottombricks.Slide
topofbricksundercliponbackofreboxwallandpush
bottom of bricks back.
5. Installsidebricks.Slidetopofbrickunderclipsonside
ofreboxandpushthebottomofthebrickuntilitisush
with the side of the unit.
D. Correct Ba󰀪e & Blanket Placement
NOTE: These are generic drawings and may not
representyourspecicmodel.
NOTE: A missing, damaged or improperly positioned
ba󰀪e is dangerous and may cause damage and poor
e󰀩ciency.Itwillalsovoidyourwarranty.
WARNING
Fire Risk.
Firebox damage due to improper ba󰀪e
placementisnotcoveredbywarranty.Operate
thewoodburningappliancewiththeba󰀪ein
the correct position only.
Notdoingsocouldresultin:
Reducede󰀩ciency
Overheatingthechimney
Overheatingtherearoftherebox
Poor performance
Ensure correct ba󰀪e placement and replace ba󰀪e
components if damaged or missing.
The ba󰀪e boards are FRAGILE. Use extreme caution
whenloadingrewoodtoprevent:
Cracking,breakingordamagingtheba󰀪eboards
DONOToperatetheappliancewithoutba󰀪eboards
CAUTION
Ceramic Blanket
Back of Firebox
Baffle Board
Baffle Retainer
Bracket
CORRECT POSITION
Figure 19.1-CorrectBa󰀪eandBlanketPositions
CeramicBlanketandBa󰀪eBoardMUSTbein contact
withthebackofthereboxandevenwitheachotherin
the front.
INCORRECT POSITIONS
CeramicBlanketandBa󰀪eBoardareNOTincontactwiththe
backoftherebox.
CeramicBlanketisNOTincontactwiththebackoftherebox
andNOTevenwiththeBa󰀪eBoardinthefront.
Figure 19.2-IncorrectBa󰀪eandBlanketPositions
CeramicBlanketisbunchedupatthebackofthereboxand
NOTevenwiththeBa󰀪eBoardinthefront.
Ceramic Blanket
Back of
Firebox
Baffle Board
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vermont Castings Gifford at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vermont Castings Gifford in the language / languages: English as an attachment in your email.

The manual is 5.34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Vermont Castings Gifford

Vermont Castings Gifford User Manual - French - 30 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info