4.1.4 Mounting/Removing the backrest
Removing
1. Turn the locks on both sides of the
backrest to “open” position [A] by turning
the lever (11).
2. Slide the backrest upwards and remove.
Mounting
1. Make sure that the locks on both sides of
the backrest are placed to “open” position
[A].
2. Slide the backrest sides on the support
(12), as far down as possible.
3. Adjust the locks on both sides of the
backrest to “lock” position [B] by turning
the lever (11). Make sure that the backrest
is well secured into position before sitting
down!
4.1.5 Handgrip position
Risk of falling
Do not exceed the maximum range as
marked on the handgrip support.
The position of the handgrips can be
steplessly adjusted to suit the user’s needs.
To make adjustment easier, 5 positions have
been marked on the handgrip support (13).
1. Loosen the lever (14) below the underarm
support.
2. Slide the handgrip forward/backward until
the desired position.
3. Tighten the lever.
4. Repeat for the other handgrip and make
sure that the hangrips are well secured.
4.2 Disassembly
Risk of damage
Pay attention to the position of the brake
cables. Don’t pull the handgrips too high
to prevent damage to the brake cable.
The disassembly of the rollator is conducted
in reverse order to the assembly:
1. Storage bag: Open snap fasteners (10)
and remove the bag.
2. Cable clamp (8) (2x): Carefully pull from
the frame tube.
3. Handgrip with brake lever (2x): Remove
the star knob. Press and hold the spring
button (5), and pull the handgrip out of the
frame.
4. Front and rear wheels (4x): Press and hold
the spring button (1), and pull the wheel
out of the frame.
CAUTION
