714713

Veritas Amelia Manual

40
Zoom out
Zoom in
Previous page
1/158
Next page
39
Bovendraad inrijgen
AANWIJZING: Het inrijgen van de bovendraad is heel
eenvoudig. Toch is het zeer belangrijk om de draad
zorgvuldig in te rijgen omdat anders problemen kunnen
ontstaan bij het naaien.
Machine inschakelen met de netschakelaar (stand “–“).
Naald eerst met de knop “Naaldstop omhoog/omlaag“
helemaal omhoog zetten (niet met het handwiel, omdat
anders de ideale inrijgpositie wordt versteld) en de
persvoet met de persvoethevel omhoog zetten om de
draadspanning los te maken.
Zet vervolgens de machine om veiligheidsredenen tij-
dens het inrijgen weer uit met de schakelaar (stand “O“).
Garenpen omhoog zetten.
Plaats de garenklos zo op de garenpen dat de draad
naar voren afwikkelt. Plaats de garenschotel op de
pen.
Trek de draad van de garenklos door de bovendraad-
geleiding.
Threading the upper thread
NOTE: Threading the upper thread is very easy.
It is important to carry out the threading correctly as
by not doing so several sewing problems could result.
First turn on the machine with the power switch
(position “–“). Start by raising the needle to its high-
est point with the button “needle up/down” (not with
the hand wheel, as this will change the best threading
position), and also raise the presser foot with the lever to
release the tension discs. Then turn off the machine (“O”
position) while threading for safety reasons.
Lift up the spool pin.
Place the spool of thread on the spool pin so that the
thread comes from the front of the spool, then place
the spool cap at the end of the spool pin.
Draw the thread from the spool through the upper
thread guide.
Enfilage du fil supérieur
REMARQUE : L’enfilage du fil supérieur est très simple
mais cela doit être fait absolument correctement, sinon
cela pourrait poser des problèmes lors de la couture.
Mettez la machine en marche grâce à l’interrupteur
(position « – »). Placez tout d’abord l’aiguille tout en
haut grâce à la touche « arrêt de l’aiguille en haut/bas »
(n’utilisez pas le volant pour cela afin de ne pas dérégler
la position idéale pour l’enfilage) et soulevez également
le pied de biche à l’aide du levier afin que la tension du fil
soit relâchée.
Pour des raisons de sécurité, il est nécessaire de débran-
cher ensuite la machine pendant l’enfilage (position « O
»).
Soulever le porte-bobine
Placez la bobine sur le porte-bobine de manière à ce
que le fil s’enfile par l’avant, puis placez le support de
la bobine sur le porte-bobine.
Enfilez le fil de la bobine à travers le guide-fil supé-
rieur.
Fil supérieur Upper Thread Bovendraad
… 40 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Veritas Amelia at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Veritas Amelia in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info