806445
45
Zoom out
Zoom in
Previous page
1/100
Next page
45
EN
PROBLEM POSSIBLE CAUSE SOLUTIONS
The appliance
does not cool at
all.
- The power has failed. - If you know about the power
failure beforehand: Set the
thermostat button in the high
mode an hour in advance,
so that the food is frozen
completely. (Do not add any
other food to freeze during this
period!) Set the temperature
mode back to the original setting
in good time when the power
supply is restored.
Strange smell in
the appliance. - There is spoiled food in the
appliance.
- The appliance is not clean.
- Food with a strong smell is
present in the appliance.
- Throw away spoiled food.
- Clean the appliance.
- Pack food with a strong smell.
The door does
not open easily. - You tried to open the door
immediately after closing.
- Wait a few seconds between
closing and re-opening the door.
The compressor
works
continuously.
- Too many products are stored at
the same time.
- The room temperature is too
high.
- The food placed in the appliance
was too hot.
- The door is not closed properly.
- Wait a few hours and then check
the temperature again.
- Please refer to Section 4.
- Allow food to cool to room
temperature before storing.
- See the next section.
There is too
much ice
formation.
- The door is not closed properly.
- The door seal is deformed or
dirty.
- The products are not packed
correctly.
- The appliance is fully
loaded and set to the lowest
temperature.
- The set temperature in the
appliance is too low and the
ambient temperature is too high.
- Find the cause of the door not
closing properly, remove or
move possible obstacles.
- As a result, the door does not
close properly. Clean the seal
and repair the deformation.
If necessary, replace the seal,
contact customer service.
- Pack the products better.
- Set a higher temperature. Please
refer to Section 4.
- Set a higher temperature. Please
refer to Section 4. If there is
more than 5 mm ice formation,
allow the freezer to defrost. See
Section 5.
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Veripart VPVR701 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Veripart VPVR701 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2.8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info