567709
34
Zoom out
Zoom in
Previous page
1/40
Next page
Figure 15: System Response Screen with Self-EQ Selected
8) You can watch the subwoofer smooth its frequency response by adjusting the parametric EQ filters on the System Response screen.
Self-EQ doesn’t change the Setup preset parameters (volume, crossover, etc.) and uses the crossover set to 160 Hz.
9)
When Self-EQ finishes, the sweep tones stop, the front status message shows End for 10 seconds, the subwoofer reboots by turning
itself of
f and back on. The subwoofer display shows the preset number and then volume level. During this process the new filter
settings are saved into the subwoofers memory.
Running Auto-EQ
PLUS
Optimization – Stepping Up in Power
The next level up in the Digital Drive
PLUS
EQ optimization methods is Auto-EQ
PLUS
optimization. To perform Auto-EQ
PLUS
optimization:
1) Set up the microphone as in the Self-EQ instructions above.
2) Connect your subwoofer to your TV video input as described above in the Make Video Connection between TV
and Subwoofer section.
3) Make sure the subwoofer and your audio system are both on.
4) Place the Digital Drive
PLUS
Sweep Tone CD into your disc player and press play.
5) Once the sweep tone starts to play, adjust the receiver or processor output level to about the level of a normal-loudness
conversation at the mic.
6) Press and hold EQ on the remote until Auto-EQ
PLUS
starts; you will see on the System Response screen the AUTO option in the
EQ MODE area. See Figure 16.
The Auto-EQ
PLUS
proceeds until one of the following occurs:
Auto-EQ
PLUS
finishes successfully, saving the settings.
You decide to quit, and press RESET on the remote. You exit back to the Introductory screen, you don’t see the Auto-EQ
PLUS
frequency response curve any more.
You move the cursor off the AUTO field (in which case the field automatically reverts to Manual-EQ).
The frequency response level is too high (peaks over 87 dB) or too low (average level below 70 dB).
The Sweep
Tone CD stops playing.
7) The Digital Drive
PLUS
subwoofer not only adjusts the Setup preset EQ filter levels as you watch, but it also adjusts the subwoofer level,
crossover, slope, and phase during the Auto-EQ
PLUS
optimization process.
8) You can also watch the status messages during the process in the upper left hand corner of the TV screen.
[ 32 ]
Digital Drive
PLUS
User Interface Manual
TV SCREEN USER INTERFACE FOR OPTIMIZATION
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Velodyne DD-12plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Velodyne DD-12plus in the language / languages: English as an attachment in your email.

The manual is 1,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Velodyne DD-12plus

Velodyne DD-12plus Quick start guide - English - 2 pages

Velodyne DD-12plus User Manual - English - 42 pages

Velodyne DD-12plus Quick start guide - German - 2 pages

Velodyne DD-12plus User Manual - German - 20 pages

Velodyne DD-12plus User Manual - German - 36 pages

Velodyne DD-12plus Quick start guide - French - 2 pages

Velodyne DD-12plus User Manual - French - 47 pages

Velodyne DD-12plus User Manual - French - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info