Important: mount the sensor first, then mount the wired handlebar holder as described under 1.2
Check the following while mounting:
a. Distance between the sensor and magnet: 1 to 5 mm
b. When mounting the sensor on a suspension fork, don’t forget to allow extra length for the cable.WATCH OUT: cable may tear
step 1: Loosely attach the sensor on the fork leg with cable ties (do not tighten yet).
step 2: Mount the magnet on a spoke. Adjust the magnet to the marking on the sensor (distance 1-5 mm).
step 3: When adjustment has been done finalise mounting by tightening cable ties and clamping magnet.
P1+P2
1.2 Mounting wire and VDO “any-size” handlebar holder
step 1: Run the cable up the fork, pass it around the brake cable from the already fixed sensor to the handlebar.
Use the enclosed cable ties or duct tape. Spiral the wire around the brake cable (this has proven to be the best solution).
step 2: position the holder on the handlebar.
step 3: feed the fixing clamp through the slot below the holder socket, pass the clamp around the handlebar and tighten it with a small screw driver.
Do not overtighten, the plastic screw might be damaged. Readjust the cable so that it will not be stretched during steering.
Finally tighten the zip ties holding the sensor.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for VDO MC 1.0 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of VDO MC 1.0 in the language / languages: English as an attachment in your email.
The manual is 0,88 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
