162090
28
Zoom out
Zoom in
Previous page
1/30
Next page
Mounting the computer
1. Connect the GPS antenna to the “GPS”
socket and the TMC antenna (accessory)
to the “TMC” socket.
2. Connect the power supply cable to the
ISO socket A’ of the navigation computer.
3. If used: Connect the signal cable to the
ISO socket B’ of the navigation computer.
4. Connect the monitor cable to the moni-
tor socket D’ of the navigation computer.
Initial operation
1. Reconnect the battery.
2. Insert SD card with the map data into
one of the computer’s SD card slots.
3. Insert batteries in the remote control
battery compartment.
If an active holder (accessory) is being
used for the remote control, in the
holder the remote control also works
without batteries.
4. Park the vehicle outdoors to ensure un-
impeded GPS reception.
5. Switch on the ignition.
The LED on the navigation computer
must light up.
The screen display appears (information
on the safe use of the system).
6. Confirm the user information using the
OK button on the remote control.
The main menu appears.
7. Wait for a few minutes with the ignition
switched on until the navigation system
has adequate GPS reception.
The integrated GPS receiver requires
approx. 2 - 10 minutes following the first
start-up to receive the system time and
to calculate an adequately accurate GPS
position.
Adapting the system
Select “Settings –> System Information
–> Diagnosis –> Code” (see also operat-
ing instructions).
Enter the code “6330”.
You can now perform the necessary ad-
aptation of the navigation computer to
the installation position and configura-
tion of the overall system.
Display adaptation
Select “Screen format”, and set the navi-
gation computer to the relevant monitor
type (4:3 or 16:9).
Setting the language for the display
text and voice messages
A description on loading languages can be
found in the section entitled “Settings” in
the detailed operating instructions on the
DVD-ROM supplied.
Adjusting the installation position
When the computer is installed overhead:
Select “Installation position” and activate
the corresponding option.
30
OPERATION SETUP INSTALLATIONCONTENTS
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for VDO Dayton pc 5200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of VDO Dayton pc 5200 in the language / languages: English as an attachment in your email.

The manual is 3,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info