22695

VDO Dayton MS 4400 Manual

59
Zoom out
Zoom in
Previous page
1/72
Next page
In rare instances, your navigation radio may not function the way you expect it to. Be
-
fore calling the service department, please read the operating instructions thoroughly
and go through the following check list; it may be possible to quickly remedy an appa
-
rent malfunction.
Symptoms Possible cause / remedy
General
Navigation radio not functioning. No display. • Check the fuse (unit and vehicle) and the connections (see installation
instructions).
Audio/ MP3 or map CD rejected by the unit. The CD may be dirty.
• Clean the CD with a special CD cleaning fluid.
The CD does not comply with the CD player’s specifications.
• See “Notes on audio and MP3 CDs”, page 8.
The operating panel of the unit feels warm. No error. The unit always generates some heat.
The volume decreases automatically.
The volume can no longer be increased.
An integrated safety circuit prevents the temperature in the unit from
exceeding a certain value.
• Allow the unit to cool down (set low volume).
System switches off the sound during driving or
display shows the “TEL” symbol.
Speedometer signal connected to the wrong pin of the power supply
connector.
• See pin setting ISO chamber A in the installation instructions.
The telephone is not being detected even
though it has been connected to the radio.
• Call up the setup menu, select “Telephone –> Signal” and select “High” for
Nokia hands-free units.
The telephone output sounds distorted. • In the setup menu under “Telephone –> Level” configure the telephone
input amplification to the hands-free unit connected.
Unit not functioning properly/ at all on some
VW/ Audi vehicles.
Some VW and Audi vehicles have different power supply connector pin
assignments (ISO chamber A).
• Please ask your dealer for a suitable adapter.
Software loading does not start although the
correct update CD has been inserted.
Software updates can only be carried out at an internal unit temperature of
+ 5 … + 60 degrees Celsius.
Radio
Poor or no radio reception. • Check if the antenna is completely extended and correctly connected.
• Check whether the supply voltage’s negative pole (brown cable) is correctly
connected to earth (vehicle chassis).
The frequency instead of the station name is
displayed.
The unit is tuned to a station that does not transmit RDS signals or the
transmitter is too weak.
The required station cannot be tuned to using
automatic search.
The desired station is too weak.
• Set desired station manually (man. tuning).
• Check whether the antenna is completely extended and correctly connected.
Tuner standard (tuner grid) wrongly set (EUR/ USA).
• Check the “Tuner Grid” option in the “Setup –> Audio” menu.
No traffic announcements are switched through
(during CDC playback).
• Activate the traffic announcements in the setup menu under “Audio –>
Traffic info”.
CD•C / MP3
Distorted sound/ skips during CD play. Player cannot read CD. CD is damaged or soiled.
CD player does not work. In cold weather conditions, condensation may occur on the laser.
• Wait for 5 minutes until the condensation evaporates.
No sound during CD playback. Some CDs contain multimedia data which is not recognised by the unit.
• Advance the tracks until music is heard.
• See “Notes on audio and MP3 CDs”, page 8.
Problems with new copy-protected audio CDs. Some copy protection procedures are incompatible with accepted standards for
audio CDs. This is not a fault on the unit.
• See “Notes on audio and MP3 CDs”, page 8.
59
Troubleshooting
… 59 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for VDO Dayton MS 4400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of VDO Dayton MS 4400 in the language / languages: English, Dutch as an attachment in your email.

The manual is 1,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info