540867

VAX V-125 Manual

14
Zoom out
Zoom in
Previous page
1/20
Next page
www.vax.co.uk
14
accessories
Lift tool, and position it against riser. Pull tool slowly over
carpet without pressing trigger (dry stroke). Overlap
strokes by 1/2 inch to help prevent streaking.
It is best to alternate wet and dry strokes as described
above. End with more dry strokes to aid in faster drying
of carpet (Fig.6/8).
NOTE: To avoid saturating carpet, do not use more than
4 wet strokes over any one area. Always end with dry
strokes.
If additional cleaning is necessary, wait until the carpet is
completely dry before using the tool again.
Empty recovery tank when the motor sound becomes
higher pitched and there is a loss in suction (see
“Automatic shut-off”, Fig. 4/5).
When finished cleaning, follow “After cleaning”
instructions on page 10 and “After using tool” instructions
on page 14.
Cleaning Upholstery
Read “Before you begin cleaning” instructions on page 6.
Be sure to check the cleaning code on your upholstery.
Use your cleaner only on upholstery marked “W” or
“W/S”.
Attach hose and solution tube as instructed.
Place handle in upright position.
Brushbar brushes will
not rotate while handle is in upright position
.
Fill clean water tank according to instructions for Figs. 4/8
to 4/10.
Fill solution container with Vax Ultra Solution according
to instructions for Figs. 4/10 to 4/11.
Attach tool to end of hose.
Do not point tools toward people or pets.
Dry hands and plug cleaner into a properly grounded outlet.
Set Wash/Rinse switch to
WASH. Turn cleaner ON
Gently press the tool onto the fabric. Press the trigger and
slowly pull the nozzle over the fabric.
Overlap strokes by 3cm to help prevent streaking.
Make additional strokes without pressing the trigger to
remove more moisture.
To clean in corners or creases, lift the tool 3cm from the
fabric and press the solution trigger.
Vacuum up the solution with the tool without pressing the
trigger (Fig. 6/9).
For heavily soiled areas, it may be necessary to repeat the
cleaning process. Make crisscrossing strokes to the original
pattern; overlap each pass (Fig. 6/10).
Fig.6/7
Fig.6/8
B
B
A
A
Fig.6/9
Fig.6/10
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for VAX V-125 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of VAX V-125 in the language / languages: English as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info