540867

VAX V-125 Manual

13
Zoom out
Zoom in
Previous page
1/20
Next page
13
V
ax Careline 0870 606 1248
accessories
How To Attach Tools
Unplug cleaner from electrical outlet.
Place handle in upright position and remove hose from
rack. All tools attach to the hose in the same manner:
Connect tool to hose by sliding it onto connector until until
the tab (A) locks it securely.Using your thumb,
push
forward and up on the latch (B) to remove tool (Fig. 6/4).
After Using Tool
Drain suction hose by turning cleaner ON and holding
nozzle up for several minutes. Do not press trigger.
Unplug cleaner from electrical outlet. Disconnect hose
and solution tube from cleaner
.
The tool caddy can be removed and hung on a coat hanger
for storage. Drain solution tube by placing round end
in sink and raising nozzle above your head. Press the
trigger (Fig. 6/5).
The tool caddy can be removed and hung on a coat hanger
for storage (Fig. 6/6)
.
Cleaning Carpeted Stairs
Read “Before you begin cleaning” instructions on page 9
.
Attach hose and solution tube as instructed previously.
Place handle in upright position.
Brushbar brushes will
not rotate while handle is in upright position.
Fill clean water tank according to instructions for Figs. 4/8
to 4/9.
Fill solution container with Vax Ultra Solution according to
instructions for Figs 4/10 to 4/11.
Attach tool to end of hose.
Hose length may require that machine be placed at the top
of the stairs to clean upper half of stairway and at bottom
of stairs to clean lower half.
IMPORTANT: To prevent machine from falling,
use extra caution when cleaning on stairs. Do
not place cleaner on stairs.
Do not point tools toward people or pets.
Dry hands and plug cleaner into a properly grounded outlet.
Set Wash/Rinse switch to
WASH. Turn cleaner ON.
Pre-spray the carpeted stair by holding the tool (A) or (B)
about one inch above the carpet and push it forward
while pressing the trigger (equals one wet stroke).
Position tool against the riser and slightly press it into
carpet pile. Press the trigger and pull the tool
slowly over
the carpet (second wet stroke). Release trigger at end
of stroke (Fig. 6/7).
Fig.6/4
A
B
Fig.6/5
Fig.6/6
!
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for VAX V-125 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of VAX V-125 in the language / languages: English as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info