POWXG6305 EN
Copyright © 2020 VARO Page | 12 www.varo.com
Note: The stop button has the highest priority, the robotic lawnmower will
stop running in any case.
To restart the mower after pressing the STOP button:
1. Make sure that all conditions for starting the mower are met (for the mower itself and
in the mowing area).
2. The status light flashes, this is the error code.
3. The lights 2D-2H-4H and 6H flash, enter the pin code, wait 5 sec.
4. Press CYCLE then HOME to exit the emergency stop mode (The status light and
the mowing setting lights 1D or 2D and 2H or 4H or 6H are steady)
5. Press START followed by CYCLE to start the mower (all lights are off), the mower
will start with a new mowing program after 10 sec.
OR
Press HOME followed by CYCLE to return the mower to the charging station (all
lights are off), the mower will start after 10 sec.
7.5.6 Change PIN code
You can change the PIN code from default (“1111”) to your own combination of 4 numbers.
The PIN code combination consists 4 digits from 1 to 4.
1. Remove the mower from the charging station (lights 2D-2H-4H and 6H are
flashing).
2. Enter the original PIN code 1111 (lights 2D-2H-4H and 6H turn off respectively)
wait 5 sec.
3. Press CYCLE and SET at the same time. (status light is steady, lights 2D-2H-
4H and 6H are blinking).
4. Enter a new PIN code consisting of 4 digits. (Light 1D is on continuously, lights
2D-2H-4H and 6H turn off respectively).
5. Lamps 2D-2H-4H and 6H will blink again. Enter the new PIN for the 2nd time.
(the status light and the mowing setting lights 1D or 2D and 2H or 4H or 6H are
steady).
Example: if you want to change the PIN to "4231":
Press “SET” for number 4 light 2D turns off
Press “HOME” for number 2 light 2H turns off
Press “START” for number 3 light 4H turns off
Press “CYCLE” for number 1 light 6H turns off
➔ When the two PINs are the same, the change is successful. After entering the new
PIN code, the status light and the mowing setting lights 1D or 2D and 2H or 4H or
6H will light up. If the status light starts blinking, the change has failed and you will
need to repeat the steps above.
