540878

Vanguard Single Cylinder Manual

59
Zoom out
Zoom in
Previous page
1/281
Next page
58
2
2. Connect starter motor (A), starter switch
(B), DC shunt (C) on negative battery
terminal (D) and meter ([E] Fig. 60).
Fig. 60
3. Activate starter motor.
• Tachometer should read 6800 RPM
minimum.
• Meter should not read more than 25
amps.
If starter motor is not within specification:
• Replace starter motor.
Check Starter Motor
(104700, 161400, 260700, 261700)
Required Equipment:
• Digital Multimeter (A), #19464
• DC Shunt (B), #19468
• Tachometer #19200, or equivalent
• A fully charged 12 volt battery ([C] Fi g.
61).
Remove starter motor from engine.
1. Set multimeter to 300mv. See Figure 7.
2. Connect starter switch (D) to starter motor
(E), battery (C), BLACK lead (G), RED
lead (H), shunt (B) and multimeter ([A]
Fig. 61).
Fig. 61
3. Note length of starter motor housing.
4. Activate starter motor.
5. Note multimeter and tachometer readings.
A starter motor in good condition will be within
specifications above.
If starter motor is not within specification:
• Replace starter motor.
Starter Motor Housing Specifications:
Housing Length
in. (mm)
Minimum RPM Maximum Amps
3.375 (85.7) 7000 24
3.656 (93) 5000 20
5.563 (116) 6500 35
… 59 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vanguard Single Cylinder at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vanguard Single Cylinder in the language / languages: English as an attachment in your email.

The manual is 8,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info