540878

Vanguard Single Cylinder Manual

58
Zoom out
Zoom in
Previous page
1/281
Next page
57
2
Test Key Switch & Solenoid
(138400, 185400, 235400, 245400)
Required Equipment:
Set meter. See Figure 8.
1. Turn the key switch ON.
2. Check for continuity at the input side (A) of
the solenoid and ground ([B] Fig. 57).
Fig. 57
If continuity is present:
• Proceed to step 3.
If not:
• Replace key switch.
3. Check for continuity at the yellow terminal
(A) of the connector coming from the
switch with the key in the START position
and ground ([B] Fig. 58).
Fig. 58
If continuity is present:
• Proceed to step 4.
If not:
• Replace key switch.
4. Reconnect the connector from the starter
switch.
5. Test for continuity at the output terminal
(A) of the solenoid with the key in the
START position and ground ([B] Fig. 59).
Fig. 59
If continuity is present:
• Replace starter.
If not:
• Replace solenoid.
Check Starter Motor
(138400, 185400, 235400, 245400)
Required Equipment:
• Digital Multimeter #19464 (E).
• Tachometer #19200
• DC Shunt #19468 ([D] Fig. 57)
• A fully charged 12 volt battery Fig. 60.
1. Set multimeter to 300mv. See Figure 7.
… 58 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vanguard Single Cylinder at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vanguard Single Cylinder in the language / languages: English as an attachment in your email.

The manual is 8,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info