540878

Vanguard Single Cylinder Manual

51
Zoom out
Zoom in
Previous page
1/281
Next page
50
2
2. Operate rocker switch and observe meter
readings.
3. The meter should show maximum or very
low resistance as the switch is moved
back and forth. Replace the switch if it
remains open or closed in both positions.
NOTE: (185430-0099-01) is wired with
components supplied by the OEM. Contact the
OEM for wiring diagrams and service
information.
Stop Switch Adjustments (161400)
1. Move remote speed control to the FA ST
position.
2. The governor control lever should not ([A]
Fig. 42) make contact with the stop switch
tang.
Fig. 42
3. Move the remote to the STOPposition.
The engine governor control lever tab
should be contacting the stop switch tang
([B] Fig. 43).
Fig. 43
If control lever does not contact stop switch
tang:
• Check control cable for adjustment or
binding. Adjust as required or replace
worn parts as needed.
• Be sure the stop switch is firmly
anchored in control bracket. Replace
switch if it cannot be anchored securely.
Key & Interlock Switches
Troubleshooting Interlock Switch (104700)
1. Disconnect interlock switch wires from
spade terminals of switch.
2. Set meter to read Ohms. See Figure 8.
3. Connect test leads to two spade terminals
([A] Fig. 44) of switch. There should be no
continuity.
Fig. 44
4. Push switch lever in until switch clicks.
Meter should read continuity.
Troubleshooting Five-Terminal Key Switch
1. Disconnect wires from key switch.
2. Set meter to test for continuity. See Figure
8.
3. Check continuity between terminals with
switch in OFF, RUN and START positions
per Key Switch Continuity Chart.
… 51 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vanguard Single Cylinder at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vanguard Single Cylinder in the language / languages: English as an attachment in your email.

The manual is 8,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info