473861
3
Zoom out
Zoom in
Previous page
1/36
Next page
3
Instructions for Utilization (Please refer to Diagrams 1 and 2)
1. Before attempting to install filter unit, make sure you set up the pool first according to the
pool’s instruction manual step by step, but do not fill it with any water.
2. Unpack the Filter and Motor (3).
3. Position the transformer (1) at least 2 meters from the pool. There are four mounting holes
(2) on the transformer use these to fix to a base if required.
4. Link one end of Outflow Hose (7) with the Motor Outlet (4) and fasten with Clamp (6); Link
the other end of Outflow Hose (7) with Pool Inlet and fasten with clamp(6) likewise.
5. Properly position the transformer and make sure that the Transformer (1) is fixed securely.
Attention: There are four Mounting Holes (2) on the bottom of Transformer (1). If trans
former needs to be mounted on the base, you can fasten the transformer with screws.
6. Fill the pool to a suitable water level after confirming that the Inflow Cover (11) is sealed.
Pool water level shall be at least 150mm above Filter Inlet (12).
7. When attempting to install the unit, open the Inflow Cover (11) of the filter, connect the
Motor (3) into the outlet on end of Transformer (1) and connect the power plug of
Transformer (1) to the electrical socket protected by a (RCD). The filter is now ready to use.
Attention (Please refer to Diagrams 1 & 2)
1. If the filter unit stops working when the power cord plug of Transformer (1) is disconnected,
immediately seal the Filter Inlet (12) with the Inflow Cover (11) connected to the end of filter
housing with fine rope, this way, any dirt can be prevented from returning to pool through the
Filter.
2. If the environment temperature exceeds the normal level and the filter unit stops running
suddenly, this indicates that the temperature safeguard device in the motor is activated. In this
case, disconnect the power plug of transformer from the electrical outlet and then reconnect
the power plug of transformer to restart the filter unit when the temperature of the motor is
back to normal.
3. Do not block the water inlet and outlet of the filter or squeeze the Outflow Hose (7) when the
filter unit is working. Otherwise, the motor may be damaged due to flow obstruction.
4. The transformer is supplied with a thermal fuse-element. The thermal fuse-element will be
blown to cut off the circuit when the temperature is up to 130
o
C and the transformer is
damaged permanently. Please replace the transformer before the filter unit is in use again.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vandermeulen AC-90577 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vandermeulen AC-90577 in the language / languages: English as an attachment in your email.

The manual is 1,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info