602563
26
Zoom out
Zoom in
Previous page
1/40
Next page
Installation instructions VRC 430f 0020042470_016
Check whether the green LED lights up at the radio
receiver unit after a short period of time.
Close the front panel of the appliance.
4.4.1 Wall mounting the wireless receiver
h
Note!
The wireless receiver only needs to be wall-
mounted if, after start-up, the receiver position
has to be changed in order to establish the best
wireless connection with the controller and the
outdoor sensor.
1
3
2
4
5
Fig. 4.1 Mounting the receiver
Key
1 Radio receiver unit
2 Wall plinth
3 Mounting openings
4 Stress relief
5 Terminal rail
Take the wall socket for the radio receiver unit.
Mark the position on the wall.
Drill two holes 6 mm diameter to match it the fixing
apertures (3).
Insert the rawl plugs supplied.
Use the screws supplied to fix the wall socket.
The electrical installation is carried out as described
in Section 5.1.
Press the radio receiver unit carefully onto the wall
socket until it snaps into place. The plug connector
on the rear of the wireless receiver unit must fit in
the plug connector provided on the wall socket.
4.5 Installing the radio outdoor sensor
The location of the radio outdoor sensor should satisfy
the following requirements:
not particularly protected from the wind
– not particularly draughty
– no direct sunlight
no influence from heat sources
N or NW facing facade
good accessibility for cleaning the solar cell
in close proximity to radio receiver unit
Whe starting up the sensor in the chosen location
check that the signal path is not adversely affected
by electrical devices or building components. If the
path is likely to be obstructed, you will have to re-in-
stall the unit in a more suitable location.
h
Note!
The outdoor sensor is powered by a solar cell.
It is therefore not necessary to change the bat-
tery.
Note!
The radio outdoor sensor must not be exposed
to direct sunlight.
Fig. 4.2 Removing the wall mount
Proceed as follows :
Mark the position on the wall.
Remove the wall bracket for the wireless outdoor
sensor (see Fig. 4.2).
4 Assembly
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vaillant VRC 430f at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vaillant VRC 430f in the language / languages: English as an attachment in your email.

The manual is 6,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info