Manual V-Zug DW Bora 9 (page 18 of 36) (English, German, Dutch, French, Italian, Portuguese, Spanish)

503574

Zoom out

Zoom in

1/36

GENERAL

Carefullyread thefollowing important informationregarding

installation safety and maintenance. Keep this information

booklet accessible for further consultations. The appliance

has been designed for use in the ducting version (air exhaust

to the outside –Fig.1B),lteringversion (air circulation on the

inside – Fig.1A) or with external motor (Fig.1C).

SAFETY PRECAUTION

1. Take care when the cooker hood is operating simultane-

ously with an open replace or burner that depend on the air

in the environment and are supplied by other than electrical

energy, as the cooker hood removes the air from the environ-

ment which a burner or replace need for combustion. The

negative pressure in the environment must not exceed 4Pa

(4x10-5 bar).Provide adequateventilation in theenvironment

for a safe operation of the cooker hood. Follow the local laws

applicable for external air evacuation.

Before connecting the model to the electricity network:

-Control the data plate (positioned inside the appliance)

to ascertain that the voltage and power correspond to the

network and the socket is suitable. If in doubt ask a qualied

electrician.

-If the power supply cable is damaged, it must be replaced

with another cable or a special assembly, which may be

obtained direct from the manufacturer or from the Technical

Assistance Centre.

2. Warning!

In certain circumstances electrical appliances may be a

danger hazard.

A)Do not check the status of the lters while the cooker

hood is operating.

B)Donot touch bulbs oradjacentareas,duringor straight

after prolonged use of the lighting installation.

C)Flambè cooking is prohibited underneath the cooker

hood.

D)Avoid free ame, as it is damaging for the lters and a

re hazard.

E) Constantly check food frying to avoid that the

overheated oil may become a re hazard.

F) Disconnec t the electrical plug prior to any

maintenance.

G)Thisapplianceis notintended for useby youngchildren

or inrm persons without supervision.

H) Young childrenshould be supervised to ensuretheydo

not play with the appliance

I) There shall be adequate ventilation of the room when

the rangehood is used at the same time as appliances

burning gas or other fuels.

L) There is a risk of re if cleaning is not carried out in

accordance with the instructions.

ThisapplianceconformstotheEuropeanDirectiveEC/2002/96,

Waste Electrical andElectronic Equipment (WEEE). By making

surethatthis appliance is disposedof in a suitablemanner, the

user is helping to prevent potential damage to the environ-

ment or to public health.

The

symbol on the product or on the accompanying pa-

perwork indicatesthat the appliance should not betreatedas

domestic waste, but should be delivered to a suitable electric

and electronic appliance recycling collection point. Follow lo-

cal guidelineswhen disposing ofwaste.For more information

on the treatment, re-use and recycling ofthis product, please

contact your local authority,domestic waste collectionservice

or the shop where the appliance was purchased.

INSTALLATION INSTRUCTIONS

Assembly and electrical connections must be carried out

by specialised personnel.

• Electric Connection:

This is a class I, appliance and must therefore be connected

to an eecient earthing system.

-The appliance must be connected to the electricity supply

as follows:

BROWN = L line

BLUE = N neutral

YELLOW/GREEN =

earth.

The neutral wire must be connected to the terminal with the

N symbolwhile the YELLOW/GREEN,wiremustbe connected

to the terminal by the earth symbol

When connecting the appliance to the electricity supply,

make sure that the mains socket has an earth connection.

After tting the ducted cooker hood, make sure that the

electrical plug is in a position where it can be accessed easily.

If the appliance isconnected directly to theelectricity supply,

an omnipolar switch with a minimum contact opening of

3 mm must be placed in between the two; its size must

be suitable for the load required and it must comply with

current legislation.

• The minimum distance between the support surfaces of

the cooking pots on the cooker top and the lowest part of

the cooker hood must be at least 65 cm. If a connection

tube composed of two parts is used, the upper part must be

placed outside the lower part. Do not connect the cooker

hood exhaust to the same conductor used to circulate hot air

or for evacuating fumes from other appliances generated by

other than an electrical source. Before proceeding with the

assembly operations, remove the anti-grease lter(s) (Fig.15)

so that the unit is easier to handle.

• We recommend the use of anair exhaust tube whichhas the

same diameter as the air exhaust outlet hole. If a pipe with

a smaller diameter is used, the eciency of the product may

be reduced and its operation may become noisier.

In thecase of assembly ofthe appliance inthe suctionversion

prepare the hole for evacuation of the air.

• Hood assembly:

-Remove the structure from the packaging and remove the

2 screws A to separate the upper part from the lower part

(Fig.2).

-Position hole template on the ceiling paying attention that

the arrow is positioned on the same side as the appliance

controls (Fig.3). Make 4, Ø8 holes in the ceiling and drive in 3

screwswithout completelytightening them. Payattentionnot

to insert thescrew into thehole marked with anX onthe hole

template (the screws and expansion plugs must be suitable

ENGLISH

- 18 -

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of V-Zug DW Bora 9 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,22 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

V-Zug DW Bora 9 Manual

Product: