484775
8
Zoom out
Zoom in
Previous page
1/34
Next page
© U.S BLASTER Design - USA - P.O. Box 5376 - Carefree - AZ 85377.
USB 7392 - 7393
Microphone systems
TRANSMITTER LOCKING
-
Press the SET button and hold it down until the LCD shows “LOCK”.
- The display will show either “LOC ON” or “LOC OFF".
(
LOCK ON means that the system is locked at a frequency. Frequency setting cannot be changed, and the
system cannot be turned off).
-
Use the Up & Down buttons to select either LOC ON or LOC OFF.
- Press the Set button again to confirm your selection
WARNING
1. If the receiver is turned on, showing cc Un LOCK" on the display, or the red LED indicator on the trans-
mitter is blinking, it means that the receiver or transmitter is out of operation. In that case, refer to your
dealer.
2. If you use more UHF systems at the same time, set the frequency of each system as far from the
other frequencies as possible to avoid interferences between the systems.
3. When inserting batteries into the transmitter (handheld type or belt case), ensure their proper polari-
ties; otherwise, it may result in damage to your transmitter.
4. Set a proper sensitivity of the receiver to obtain the best possible reception.
TECHNICAL SPECIFICATIONS
General
Mode:..................................................................................................................................PLL
Frequency range:.............................................................................................520Mhz - 820Mhz
Modulation: .........................................................................................................................FM
Maximum deviation:.....................................................................................................+/-45 Hz
Frequency response: ............................................................................80Hz - 15 KHz (+/-3dB )
Operating temperature:................................................................................. -10 ºC do + 5O ºC
Handheld transmitter
T
r
ansmitting output:...................................................................................25 to 30mW Dynamic
Chamber:
....................................................................................................................
Dynamic
Batteries:
...................................................................................................2 x 1.5V, alkaline AA
Receiver:
Sensitivity: ...................................................................................................................12dBuV
Sensitivity range: ..................................................................................................12 to 32 dbU
S
ymmetrical output:
..................................................................................
0 to 0.5V / 600 Ohms
Asymmetrical output: ................................................................................0 to 0.5V / 600 Ohms
P
ower supply:
...........................................................................................................DC 12-14V
P
ower consumption:........................................................................................................300mA
© US Blaster Europe BV
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for US Blaster USB 7393 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of US Blaster USB 7393 in the language / languages: English as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info