557953
10
Zoom out
Zoom in
Previous page
1/34
Next page
10
INTERFERENCE
Interference occurs when radio waves or electronic signals are blocked or
interrupted by consumer electronic products. In the case of a weather station,
the signal from the transmitter to the receiver may be interrupted by a wireless
telephone, or other electronic equipment. Additionally, if your next door neighbor
is operating a similar weather station, your receiver might pick up a signal from
their temperature sensor by mistake. The solution to undesired interference is to
set your temperature sensor(s) on a specific frequency (or house code) which
ranges from 1-15. (This house code setting may be applied to the temperature/
humidity transmitter (WT440H) only, not to the wind or rain gauges in this kit.)
Setting the House Code
The house code is the frequency signal sent by the remote sensor to the
receiver. If the receiver experiences signal interference, you will need to set the
remote sensor to a different house code (default setting = 1).
After inserting the batteries, the house code will flash for 8 seconds. Select a
house code (1-15) by pressing ºCF (Diagram C [2]) and then press SET
(Diagram C [1]). The remote sensors for each receiver must be set to the
same house code.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for UPM WS2635 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of UPM WS2635 in the language / languages: English as an attachment in your email.

The manual is 0,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info