557953
8
Zoom out
Zoom in
Previous page
1/34
Next page
8
TRANSMITTER SETUP
Before following the steps below, make sure you have the following items:
- Compass (not included)
- 9 x AA batteries (included)
- 10 screws (included)
Setting the wind gauge
The wind gauge is a sensor that transmits the wind speed and the direction to
the receiver.
1. To install, (see diagram F)
2. There are 3 methods to mount the wind gauge (See diagram H).
If you are installing the shaft in a horizontal position, remove the cap first.
Note: 4 plugs are provided to screw the wind gauge’s plate to a
concrete or brick surface.
Note: Before mounting, you must use a compass to align the “N”marking on
the plate of the wind gauge so that it is facing north (see diagram I).
To see the North marking, you must temporarily remove the wind gauge fin.
This step is necessary to indicate the correct wind direction.
3. Mounting the wind gauge (see diagram I)
Note: Mount the wind gauge in an open space, as high as possible and
without any nearby walls or obstacles, in the direct flow of the wind.
- attatch the cups to the wind sensor body with the 3mm x 8mm screws.
- make sure the top of the wind gauge is stable and level.
- To enure the most accurate readings, make sure that the wind cup and the fin
are freely mobile.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for UPM WS2635 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of UPM WS2635 in the language / languages: English as an attachment in your email.

The manual is 0,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info