Manual Unold 78526 (page 18 of 60) (English, German, Dutch, French, Italian, Spanish)

484990

Zoom out

Zoom in

1/60

1. Make sure that the appliance is not plugged

into the electrical outlet. The speed switch

must be set to „AUS“ (OFF).

2. Make sure that the motor block is positioned

firmly on the kitchen countertop.

3. Press the release button.

4. The swivel arm moves upward.

5. Select the desired mixing utensil:

T-mixing hook: cake batter, mashed

potatoes, spaetzle dough

Kneading hook: yeast dough, bread

dough, noodle dough

Wire whisk: beating of eggs, cream,

waffle batter, biscuit dough and all

various mousses. Do not use the wire

whisk for heavy doughs, because it

could bend or break.

6. Attach the desired mixing utensil. Make

sure that the mixing utensil is attached so

that the notch on the mixing utensil mat-

ches the driver pin on the axle of the swivel

arm. Turn the mixing utensil clockwise until

it is tightly seated.

7. Make sure that the mixing utensil locks into

place, since otherwise the ingredients can-

not be mixed properly.

8. Now place the mixing bowl under the swivel

arm. Place the bowl in the holder and turn it

clockwise until it locks into place.

9. If desired, you can now put the splash

guard on the mixing bowl. Press the splash

guard firmly onto the bowl so that it cannot

slip. The splash guard provides protection

against splashing, but also makes it easier

to add additional ingredients. If you wish to

change the mixing utensil in between, the

splash guard does not have to be removed.

10. Press the release button and push the swivel

arm down until it locks into place. You will

hear a click when the swivel arm locks cor-

rectly into place.

     

     

   



11. To disassemble the appliance, perform the

above steps in reverse sequence.

1. Make sure that the appliance is not plugged

into the electrical outlet. The speed switch

must be set to „AUS“ (OFF).

2. Check to make sure that the appliance has

been assembled correctly.

3. Plug the power cord into an electrical outlet.

4. Switch on the appliance by setting the speed

switch to „ON“ (EIN). Select a lower speed

at the beginning. You can adjust the speed

continuously up to the „Max“ position.

5. The individual Levels from 1-6 are suitable

for the following steps. Always begin with a

low speed and then slowly switch to a higher

speed. In doing so, you avoid spraying and

raising dust from the ingredients.



Mixing of ingredients without having to

crush coarse ingredients (e.g. pieces of fruit

in cream) or for marbling (stirring fruit puree

in curd cheese).



Addition of flour, ground nuts, etc. into

dough so that dust is not raised from the dry

ingredients. Mixing of ingredients without

spraying.



Whipping cream - cream has greater volume

when it is whipped slowly.



Whipping egg whites, stirring batter,

kneading dough.



Kneading heavy dough. Attention: Begin

mixing this dough at a lower level.

6. If too much dough sticks to the edge of the

bowl, switch the appliance off in between

and unplug it from the electrical outlet.

Move the swivel arm upward and use a spa-

tula to scrape the dough from the edge of

the bowl.

7. When your dough is finished, switch off the

appliance by setting the speed switch to

„AUS“ (OFF) and unplug it from the electri-

cal outlet. Move the swivel arm upward and

remove the bowl.

8. Use the dough as desired.

9. Remove the mixing utensil and clean the

mixer as described in „Cleaning and care“.

assembly

operation

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Unold 78526 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 2,05 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Unold 78526 Manual

Product: