Manual Unold 28716 (page 19 of 66) (English, German, Dutch, French, Italian, Spanish)

484982

Zoom out

Zoom in

1/66

9. Remember that the coffee beans container

always has to be half full. The maximum

capacity is of approx. 240 g.

10. Do not overfill the coffee beans container, in

order to avoid damage to the grinder.

11. Close the coffee beans container with the

lid.

12. Adjust the grinding selector to the desired

degree of grinding. You can select between

coarse, medium and fine in nine steps.

13. Connect the plug to the wall socket.

14. The appliance indicates the readiness for

operation by beeping two times.

15. Check if the clock is adjusted to the actual

time as described in the chapter “Adjusting

the clock”. Push the button “PROG” until

the backlight of this button flashes blue.

16. Select the desired number of cups pushing

the button “2-10 TASSEN” [2 - 10 cups]

until the desired number of cups lights up.

You may choose between 2, 4, 6, 8 and

10 cups. Please make sure to select exactly

the number of cups that have been pou-

red in. If you poured in water for two cups,

you have to select two cups, if you poured

in water for four cups, you have to select

four cups and so on. This guarantees the

optimum coffee taste. The coffee machine

grinds exactly the right amount of coffee

beans.

17. Now you may select the strength of the

coffee by pushing the button “STÄRKE”

[strength]. You can select between coarse,

medium and fine in nine steps.

18. If you desire, you may also prepare coffee

from coffee powder. For this purpose, please

push the button “MÜHLE AUS” [MÜHLE

OFF]. The backlight of this button flashes

blue as long as the button is active. The cof-

fee machine will not grind any coffee beans,

, until the button is pushed again. Fill the

permanent filter with the desired amount

of coffee powder, using 5 – 7 g (approx.

1 coffee measuring spoon) of medium fine

ground coffee per cup according to the desi-

red strength. Too finely ground coffee may

clog the pores of the filter and cause spil-

ling.

19. Press the flap slightly until it latches into

place.

20. Put the glass jug with the lid closed on the

heating plate.

21. Now select the desired time at which the

coffee machine shall start preparing the

coffee by pushing the buttons “STD” and

“MIN”.

22. Then push the button “PROG” again. The

blue backlight illumination indicates that

the appliance is in timer mode and will start

preparing coffee at the desired time.

23. At starting time the appliance starts prepa-

ring coffee.

24. You may remove the jug at any time during

the brewing process. The drip-stop avoids

the coffee dripping from the filter. Put the

jug back on the filter within 30 seconds in

order to continue the brewing process and to

avoid spilling from the filter.

25. The appliance indicates that the coffee is

ready by beeping five times. Switch the

appliance off pushing the button “EIN/

AUS” [ON/OFF]. The heating plate will con-

tinue working as long as the coffee machine

is not switched off, in order to maintain the

temperature of the coffee remaining in the

jug. After two hours the appliance is auto-

matically switched off.

26. The programming remains as long as the

appliance is connected to the mains. If you

wish to prepare coffee at the set time, you

simply need to press the “Program” button

again.

27. After having poured out all the coffee, do

not leave the empty coffee jug on the hot

heating plate.

28. Remove the permanent filter and empty the

coffee grounds.

CLEANING AND CARE

1. Before cleaning, always turn the appliance off and

unplug it from the wall socket.

2. Allow the appliance to cool off before cleaning it.

3. Do not immerse the appliance and the lead

cable in water or other liquids or wash them

in the dishwasher.

4. Open the lid of the appliance and remove

the permanent filter. Dispose of the coffee

grounds.

5. Above the filter water may condense. After

preparing coffee, clean the bottom side of

the lid with a dry cloth.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Unold 28716 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,07 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Unold 28716 Manual

Product: