647633
10
Zoom out
Zoom in
Previous page
1/16
Next page
WARNING.. When you first hear the beep toae, you should turn the
unit off and immediately replace your batteries (or recharge if NiCad
batteries are used) to avoid losing memory. When you replace weak
batteries, you must install the new ones immediately to keep the sca-
nner memory. Be sure to read the "Installing Batteries" section of this
guide before attempting to replace your batteries.
HELPFUL HINTS
The following hints are provided to help you get the most out of your new scan-
ner. By reading this entire guide, including this section, you will better under-
stand and enjoy your new Uniden(ii)Bearcat(ii)50XL.
1. Always remember to press the enter key when programing a frequency. If
the enter key is not pressed the frequency will not be programmed into that
channel. It is a good idea to press the review key after entering a frequency
to confirm that the correct number was entered.
2. If you ever have to ship the unit. be sure to remove the antenna and place
it and the unit in the original styrofoam inner packing and box. One of the
most common causes of damage to electronic products is improper pack-
ing when shipping.
3. Remember that the liquid crystal display is subject to permanent damage
if it is exposed to extremes in temperature or humidity. Take extra care with
your scanner in the winter and on sunny, summer days.
4. The Uniden(ii)Bearcat(ii)50XL never sleeps-its memory is always active
even though the power is turned off. Battery drain in the off mode is almost
as Iow as the discharge rate of the batteries alone. As long as you observe
the battery Iow indicator and act accordingly, you shouldn't have any prob-
lem with memory loss.
5. Receiver sensitivity is affected by the location of the antenna and the en-
vironment that the unit is used in. Best reception will occur when the unit
is placed on a level metal surface with the antenna pointing up. Placing
the unit close to a window will also provide better reception.
6. Receivers, such as the Uniden@Bearcat(ii)50XL, which have broad tuning
ranges are subject to interference from internally generated signals ("Bir-
dies") on a few receiver frequencies. On these frequencies, reception of
external signals may be impaired. Nothing is wrong with your scanner if
this kind of interference occurs, unless it happens on a large number of
frequencies.
10
-J
-_.~ "- ------.
~
I
\
\
I
I
I
I
)
J
I
I
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Uniden BC50XL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Uniden BC50XL in the language / languages: English as an attachment in your email.

The manual is 3,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info