Manual Ultimate speed ULG 12 B3 - IAN IAN 290923 (page 11 of 54) (English, German, Dutch, Danish)

670236

Zoom out

Zoom in

1/54

GB/NI/IE 11

Operation

Note: If the connection terminals are connected

correctly, the display indicates the voltage and

the display "connected" lights up. If polarity is

reversed, the display shows 0.0 and the display

"connected" does not light up.

 Disconnecting

 Disconnect the device from the mains current.

 Disconnect the "–"-pole quick contact-connec-

tion terminal (black)

from the "–"-pole of

the battery.

 Disconnect the "+"-pole quick contact-connec-

tion terminal (red)

from the "+"-pole of

the battery.

 Reconnect the plus pole connection cable of

the battery to the plus pole of the battery.

 Reconnect the minus pole connection cable of

the battery to the minus pole of the battery.

 Choosing the charging

mode

You can choose from different charging modes for

charging different batteries at different ambiance

temperatures. As compared to conventional car

chargers, this device has a special function for

reuse of a flat battery/rechargeable battery. You

can recharge a completely discharged battery/

rechargeable battery. Protection against wrong

connection and short circuit ensures safe charging.

The integrated electronics do not start the car char-

ger at once after connection of the battery, but only

after a charging mode has been selected.

If the connection terminals are connected to the

battery and the device is connected to the mains,

the digital display

will show "Connected". After

the charging mode has been selected, the display

"Charging" lights up. When charging is complete,

the display "Charged" lights up.

If the digital display is continually lit before the

battery is completely charged, there is a defect.

 In this case, check again if the connection

terminals

are correctly attached to the

battery and whether the correct battery type

has been chosen. If the display lights up

continually anyway, there may be a defect in

the battery.

Digital display button

: Permits replacing of

the digital display of the voltage and the charging

progress in percent (battery %). Use this button in

order to switch between the following displays:

– Battery %: shows the charging progress of the

connected battery in percent.

– Voltage: shows the voltage of the connected

battery.

– Alternator %: Output power in percent

Battery type button

: Use this button to set

the type of the battery to be charged. You can

choose between different battery types here. The

battery type must be set correctly before charging

commences:

– 12 V Regular: These batteries (lead-acid bat-

teries) are usually used in cars, trucks and

motorcycles. They have venting caps and are

often marked as "low-maintenance" or "no

maintenance". This battery type is meant for

transferring energy quickly (e.g. starting an

engine). "Regular" batteries should not be used

for "Deep Cycle" applications.

– 12 V Deep Cycle: These batteries are usually

also marked as "Deep Cycle" or "Marine".

Batteries of this type are usually larger than

other battery types. This supplies less short-term

energy, but a longer-term energy transmission.

These batteries can withstand a large number

of discharge cycles.

– 12 V AGM/gel: The battery types AGM

are usually good deep cycle batteries. They

have the best "service life" when they are

recharged before they have been discharged

by more than 50%. At complete discharge,

they can withstand about 300 charge cycles.

The battery type GEL is similar to the battery

type AGM. The voltage at recharging is lower

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ultimate speed ULG 12 B3 - IAN IAN 290923 in the language / languages: English, German, Dutch, Danish as an attachment in your email.

The manual is 1,26 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ultimate speed ULG 12 B3 - IAN IAN 290923 Manual

Product: