Removing obstructions
In the event that the Cycle-Tech unit
becomes blocked, release the two hol-
ding catches, take the lid off the container
and remove whatever caused the
blockage (fig. 17).
Put the lid back on the container and press
it in the direction of the arrow until you
hear the two catches click back into
position (fig. 18). Do not forget to clean
the permanent filter and micro-filter (figs.
15 and 16)
FITTING & REPLACING THE DUST
BAG
When the suction decreases considerably
and the bag full indicator in the lid is
completely yellow, this indicates that the
bag is full. To change it, open the general
compartment (fig. 1) pull the hygienic seal
back to stop any dust from escaping (fig.
19) and take the bag out of the filter hol-
der. Fit a new dust bag (fig. 4).
IMPORTANT
• The lid of the vacuum cleaner will not
close unless either a bag or the Cycle-Tech
unit is fitted. Do not force it shut, check
that the bag is fitted correctly.
• If after having changed the bag the
suction is still irregular and the bag full
indicator stays yellow, check that there is
no blockage in the suction hose, tube or
air intake.
• Never use the vacuum cleaner without
a bag or try to empty a full bag and then
reuse it.
• To guarantee trouble free operation only
use original Ufesa bags which can be
found at authorised establishments.
Replacement bag reference: FA0130.
REPLACING THE MOTOR
PROTECTION FILTER
This vacuum cleaner is equipped with a
HEPA H12 filter. This filter must be
replaced each year. To do this, just pull
the used filter out of it housing (fig. 20) and
slide a new filter back into the slot. Make
sure that the word “TOP” on the filter is at
the top. Replacement HEPA filter
reference: FA0500.
IMPORTANT: The vacuum cleaner must
never be switched on unless this filter is
fitted correctly.
CLEANING
Unplug the vacuum from the mains supply
before cleaning it. The accessories and the
vacuum can be wiped clean with a damp
cloth and then left to dry before reusing
them. Never immerse the appliance in
water. Do not use solvents or abrasive
products to clean it.
ADVICE ON DISPOSAL
Our goods are shipped in optimised
packaging. This basically consists in using
non-contaminating materials which
should be handed over to the local waste
disposal service as secondary raw
materials. Your local town council can give
you information about how to dispose of
obsolete appliances.