To make tea, bouillon or any other hot drink, you can use your machine to
obtain fresh hot water:
Take out the water tank and fill it with water.
Connect power.
Turn power switch to ●. The red display, showing the machine is ready to
operate, will light up.
Hold the cup under the steam pipe.
Open the steam valve (on the right side of the machine) and turn the left
knob to .
When you have as much water as you need, turn the left knob to ● and
close the steam valve.
Clean the steam pipe after every time it is used, so that the nozzle and the
small openings in the pipe do not get blocked 10. Milk that has dried on can
be difficult to remove subsequently.
To clean, hold a damp cloth firmly below the nozzle and open the steam
valve. Leave the valve open for one or two seconds, to clean the nozzle. Then
wipe the surface of the steam pipe with the damp cloth.
The steam pipe may be removed. Simply turn it a little, and pull firmly. To
clean it, soak it in hot water, then rinse and replace. If necessary you can
also use a needle to clean the openings in the steam pipe.
From time to time you should also unscrew the nozzle at the bottom of the
steam pipe and clean it carefully.
The sieve support and sieve should be cleaned after use with water and a
small quantity of detergent.
Remove the drip tray and drip grate and clean them with warm water and
a small quantity of detergent. For cleaning the drip tray, we would advise you
to use a damp sponge.
Coffee grounds have a tendency to collect on the brewing head insulating
seal. You should keep the seal clean, otherwise the taste of your coffee will
be impaired.
If the coffee machine has not been used for some time, before making coffee
you should first remove the standing water that remains in the hose system.
First fill the water tank with fresh water. Then turn the left knob to . After
a few seconds, again turn the knob to . The stale water will now have
been removed from the hose system.
Important:
Never activate the left knob when there is no water in the water tank, or
the pump could be damaged.
3.9. Hot water supply
9
3.10. Cleaning the machine
10
