Manual Trumatic Combi 4 E (page 13 of 72) (English, German, Dutch, Danish, French, Italian, Spanish)

484617

Zoom out

Zoom in

1/72

Function description

The liquid gas heater Combi E is a warm-air heater with inte-

grated hot water boiler (10 litres volume). The burner operates

fan-supported, which ensures trouble-free function even when

on the move. The unit also has heating elements for electrical

operation.

In winter operation the heater can be used to heat the

room and simultaneously warm water. If only warm water is

required, select summer operation.

At a temperature of approximately 3 °C at the automatic

FrostControl safety/drain valve, the valve will open and drain

the boiler.

3 different options are available for operating the unit.

gas operation only

Propane / Butane for autonomous use

electrical operation only

230 V for stationary use on camp sites

or gas and electrical operation – mixed operation

only possible in winter mode.

Winter operation

In winter operation, the unit automatically selects the

required power setting according to the temperature differ-

ence between the temperature set on the control panel and

the current room temperature. When the boiler is filled, the

water is automatically heated as well. The water temperature

depends on the selected operational mode and the heater

output.

All 3 energy selection options can be used for winter

deployment.

With gas operation the unit automatically selects the out-

put level that is required.

Depending on the fuse protection at the camping site,

power of 900 W (3.9 A) or 1800 W (7.8 A) can be manually

selected for electrical operation.

If more output is required (e.g. heating up or low outside

temperatures) gas or mixed operation should be selected so

that enough heating power is always available.

With mixed operation, 230 V electrical operation is pre-

ferred if the power requirement is low (e.g. for maintaining

the room temperature). The gas burner is not enabled until

the power requirement is higher, and is the first to switch

off during

heat-up operations.

Summer operation

(boiler operation only)

Gas operation or 230 V electrical operation is used for hot

water preparation. The water temperature can be set to 40 °C

or 60 °C.

With gas operation the water is heated at the lowest

burner setting. Once the water temperature is reached, the

burner switches off.

Depending on the fuse protection at the camping site,

power of 900 W (3.9 A) or 1800 W (7.8 A) can be manually

selected for electrical operation.

Mixed operation is not possible. With this setting the

unit automatically selects electrical operation. The gas

burner is not enabled.

–

Safety instructions

The use of upright gas cylinders from which gas is taken in

the gas phase is mandatory for the operation of gas regula-

tors, gas equipment and gas systems. Gas cylinders from

which gas is taken in the liquid phase (e. g. for fork lifts) must

not be used, since they would result in damage to the gas

system.

If the gas system is leaking or if there is a smell of gas:

extinguish all open flames

open windows and door

close all quick-acting valves and gas cylinders

do not smoke

do not activate any electric switches

ask an expert to inspect the entire system!

Repairs may only be carried out by an expert!

Guarantee claims, warranty claims and acceptance of liability

will be ruled out in the event of the following:

modifications to the unit (including accessories),

modifications to the exhaust duct and the cowl,

failure to use original Truma parts as

replacement parts and accessories,

failure to follow the installation and operating instructions.

It also becomes illegal to use the appliance, and in some

countries this even makes it illegal to use the vehicle.

The gas supply’s operating pressure (30 mbar) must be the

same as the unit’s operating pressure (see type plate).

Liquid gas systems must comply with the technical and ad-

ministrative regulations of the respective country of use (e.g.

EN 1949 for vehicles in Europe). The national legislation and

regulations (e.g. DVGW Work Sheet G 607 for vehicles in

Germany) must be observed.

In Germany, the gas system must be retested every 2 years by

a liquid gas specialist (DVFG, TÜV, DEKRA). The test must be

confirmed on the respective test certificate (G 607).

The vehicle owner is always responsible for arranging the

inspection.

Liquid gas equipment may not be used when refueling, in

multi-storey car parks, in garages, or on ferries.

During the initial operation of a brand new appliance (or after

it has not been used for some time), a slight amount of fumes

and smell may be noticed for a short while. It is a good idea to

heat the device up several times in summer operation (60 °C)

and to make sure that the area is well ventilated.

Heat-sensitive objects such as spray cans or flammable liquids

may not be stored in the same compartment where the heater

is installed because, under certain conditions, this area may

be subject to elevated temperatures.

Only pressure regulating equipment that complies with

EN 12864 (in vehicles) with fixed output pressure of 30 mbar

may be used for the gas system. The flow rate of the pressure

control device must correspond to at least the maximum con-

sumption of all devices installed by the system manufacturer.

We recommend the gas pressure control systems Truma

SecuMotion / MonoControl CS for vehicles and the Truma

gas pressure control systems DuoComfort / DuoControl CS

for dual-cylinder gas systems.

At temperatures of around 0 °C or less the gas pressure regu-

lator and the changeover valve should be operated using the

EisEx regulator heater.

–

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Trumatic Combi 4 E in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 2,94 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Trumatic Combi 4 E Manual

Product: