Manual Truma Saphir comfort (page 14 of 54) (English, German, Dutch, Danish, French, Italian, Spanish)

489375

Zoom out

Zoom in

1/54

Technical data

Determined on the basis of EN 14511 and the Truma test

conditions.

Designation

Saphir comfort IR, Comfort air conditioner

Area of operation

Small areas, mobile and stationary

Number of installation units

Dimensions (L x W x H)

710 x 400 x 290 mm

Weight

approx. 22.5 kg

Power supply

230 V – 240 V ~, 50 Hz

Maximum cooling capacity

2.4 kW

Actual power consumption

0.98 kW

Start-up current

20 A (150 ms)

Current consumption

4.2 A

Protection mode

IP X5

Energy Efficiency Rate (EER)

2.4

Volume flow (cold air)

max. 380 m³/h

Cooling agent

R 407C

Cooling agent content

see type plate on the device

Compressor oil

Diamond MA32, 300 cm³

Noise

Depending on installation situation

Maximum inclination of vehicle during operation

5° / 8 %

Operational limits

+16 °C to +40 °C

Below +16 °C an ambient air sensor prevents the operation

of the compressor.

An icing sensor prevents impermissible formation of ice on

the evaporator.

A temperature switch pre vents excess current flow and

excess temperature at the compressor.

Declaration of conformity

The device satisfies the requirements of the following EC

Directives:

EMC Directive 2004/108/EC

Low-Voltage Directive 2006/95/EC

Noise Suppression in Vehicles 2004/104/EC, 2005/83/EC,

2006/28/EC

Type approval number e1 03 4392

Pressurised Equipment Directive 97/23/EC

End-of-Life Vehicle Directive 2000/53/EC

Right to effect technical modifications is reserved!

Evaporator

Condenser

Circulating

air suc-

tion intake

from inside

Cold air

outlet

Supply air

infeed from

the outside

Supply air

discharge to the

outside-downwards

Throttle

Compressor

Low-pressure side

High-pressure side

Fan

Filter

Function diagram

–

Manufacturer’s terms of warranty

1. Case of warranty

The manufacturer grants a warranty for malfunctions in the

appliance which are based on material or production faults.

In addition to this, the statutory warranty claims against the

seller remain valid.

A claim under warranty shall not pertain

for parts subject to wear and in cases of natural wear

and tear,

as a result of using components in the units that are not

original Truma parts,

for gas pressure regulation systems as a result of damage

by foreign substances (e.g. oils, plasticisers) in the gas,

as a consequence of failure to respect Truma instructions

for installation and use,

as a consequence of improper handling,

as a consequence of improper transport packing.

2. Scope of warranty

The warranty is valid for malfunctions as stated under item 1,

which occur within 24 months after conclusion of the pur-

chase agreement between the seller and the final consumer.

The manufacturers will make good such defects by subse-

quent fulfilment, i.e. at their discretion either by repair or

replacement. In the event of manufacturers providing service

under warranty, the term of the warranty shall not recom-

mence anew with regard to the repaired or replaced parts;

rather, the old warranty period shall continue to run. More ex-

tensive claims, in particular claims for compensatory damages

by purchasers or third parties, shall be excluded. This does not

affect the rules of the product liability law.

The manufacturer shall bear the cost of employing the Truma

customer service for the removal of a malfunction under war-

ranty – in particular transportation costs, travelling expenses,

job and material costs, as long as the service is carried out in

Germany. The warranty does not cover customer service work

in other countries.

Additional costs based on complicated removal and installa-

tion conditions of the appliance (e.g. removal of furniture or

parts of the vehicle body) do not come under warranty.

3. Raising the case of warranty

The manufacturer‘s address is:

Truma Gerätetechnik GmbH & Co. KG

Wernher-von-Braun-Straße 12

85640 Putzbrunn, Germany

Always notify the Truma Service Centre or one of our author-

ised service partners if problems are encountered (see Truma

Service book or www.truma.com). Please describe you com-

plaint in detail and state the factory number of the device and

the purchase date.

In order for the manufacturer to be able to determine whether

an incident subject to guarantee has occurred, the end user

must, at his own risk, bring or send the device to the manu-

facturer. If there is damage to heat exchangers, the gas pres-

sure regulator must also be sent back to the factory.

Air conditioners:

To avoid transportation damage, the unit may only be sent to

the Truma Service Centre Germany or one of our authorised

service partners if agreed beforehand. Otherwise the sender

bears the risk for any transportation damage.

Please send all shipment to the factory as freight. In cases

under guarantee, the works shall bear the transport costs or

the costs of delivery and return. If the damage is deemed not

to be a warranty case, the manufacturer shall notify the cus-

tomer and shall specify repair costs which shall not be borne

by the manufacturer; in this case, the customer shall also bear

the shipping costs.

–

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Truma Saphir comfort in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 7,43 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Truma Saphir comfort Manual

Product: