590215

Truma Mover XT2 Manual

17
Zoom out
Zoom in
Previous page
1/96
Next page
17
General instructions
The Mover®XT has been designed to cope with inclines of up
to approx. 25 % bearing a gross weight of 1200 kg or 13 %
bearing a gross weight of 2300kg on a suitable surface.
The Mover®XT2 has been designed to cope with inclines of
up to approx. 25 % bearing a gross weight of 1200 kg or 10 %
bearing a gross weight of 2400kg on a suitable surface.
Depending on the weight of the caravan, the Mover®XT / XT2
may not be able to overcome obstacles more than about
3cm in height without auxiliary equipment (please use ascent
chocks).
As a result of the characteristic properties of a radio signal, it
may be interrupted by terrain / objects. This reduces recep-
tion quality in small areas around the caravan, as a result of
which the operation of the Mover®XT / XT2 may be briefly
interrupted.
When the Mover®XT / XT2 is switched off using the re-
mote control, the control unit remains in standby. In or-
der to switch off completely the battery must be disconnected
or an isolating switch installed.
Batteries
For optimum operation we recommend the Truma Mover®
PowerSet, which contains batteries with button cells and an
appropriate charger. So-called drive, lighting and gel batteries
with sufficient capacity are also suitable.
Recommended battery capacities
Button cell technology at least 38 Ah
Gel / AGM at least 48 Ah
Lead-acid battery (liquid electrolyte) at least 75 Ah
Starter batteries are not suitable
Batteries with greater capacity allow the equipment to
be used for longer.
Charger
For optimum battery charging we recommend the Truma
BC 10 charger, which is suitable for all battery types up to
200 Ah.
Battery care (including maintenance-free
batteries)
In order to achieve a long battery service life, attention must
be paid to the following points:
– Batteries should be fully charged before and after removing
power,
– for stationary periods of longer than 24 hours, interrupt
power circuit (e.g. using circuit breaker or by disconnecting
the battery poles),
– for longer stationary periods, the battery must be discon-
nected and charged for 24 hours at least every 12 weeks.
In winter, store the fully charged battery in a cool and
frost-free place and recharge at regular intervals (every
12 weeks).
Function description
Always observe the operating instructions and the
“Safety instructions” prior to starting! The vehicle owner
is responsible for correct operation of the device.
Please note that the Mover®XT is only suitable for sin-
gle-axle trailers, while the Mover®XT2 is only suitable
for dual-axle trailers.
The Mover®XT / XT2 is a manoeuvring system which allows
a caravan to be manoeuvred without the aid of the towing
vehicle.
It consists of two separate drive assemblies, each with its
own 12V DC motor. These units are mounted on the frame
of the vehicle in the immediate vicinity of the wheels, and are
connected by a lateral bar.
Once the drive rollers have been engaged using the remote
control, the Mover®XT / XT2 is ready for operation. It is op-
erated exclusively via the remote control, which transmits
radio signals to the control unit. A separately installed 12V
lead-acid battery or suitable lead-gel battery (not supplied)
provides the control unit with electrical power.
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Truma Mover XT2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Truma Mover XT2 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish as an attachment in your email.

The manual is 11,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info