629585

Truma MonoControl CS Manual

14
Zoom out
Zoom in
Previous page
1/68
Next page
14
– Close the gas cylinder valve.
– Remove the high pressure hose from the gas cylinder (or
from the slip‑on adapter) and from the regulator inlet.
When changing the hose, ensure that the seal provided
with the hose (hose outlet, regulator inlet) is correctly
installed and not damaged.
We recommend that the seal (part no. 50020‑76300) be
replaced every time the hose is changed.
– Screw the country‑specific high‑pressure hose to the
MonoControl CS inlet and to the cylinder (or the slip‑on
adapter).
– Open the gas cylinder valve.
– Firmly press the hose rupture protection (green button) and,
if necessary, the green reset button for about 5 seconds in
each case.
Check the hose connection on the cylinder valve and at the
MonoControlCS inlet for leaks after every modification (see
“Checking for leaks in the high‑pressure section”).
Checking for leaks in the high-pressure
section
The screw joints of the high‑pressure hoses at the gas cylin‑
der valve and on the MonoControl CS should be checked for
leaks using suitable means such as a leak‑finder spray in ac‑
cordance with EN 14291.
The operator is responsible for this.
Checking for leaks in the low pressure
section
(maximum test pressure 150 mbar)
The test must be conducted by a technician!
The gas hose and gas cylinder must be connected.
– Turn off all consumers.
– Open stop valves and, if present, the gas remote switch.
– Remove the threaded cap from the test connection (b)
and connect the test pump with test hose to the test
connection.
b
Figure 2
– Perform a leak test (e.g. in Germany according to G 607).
– If gas system exhibits a leak, close the gas cylinder valve
and have the gas system repaired immediately by an expert;
do not open the gas cylinder valve until repair is complete.
– When testing is complete, screw the threaded cap back
onto the test connection.
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Truma MonoControl CS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Truma MonoControl CS in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish as an attachment in your email.

The manual is 3,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info