489383

Truma BM 14 Manual

20
Zoom out
Zoom in
Previous page
1/68
Next page
20
Connect the cable, 230 V lead, and heating bar cable as
shown in the circuit diagram.
1 = Control device cable
2 = Supply pipe 3 x 1.5 mm²
3 = Heating element cable
4 = brown
5 = green
6 = blue
7 = yellow
8 = white
9 = yellow/green
Fig. K
Connect distribution socket (57) to floor of vehicle or to the
wall near the device (cable length 150 cm).
Gas connection
The gas supply’s operating pressure (30 mbar) must
be the same as the unit’s operating pressure (see type
plate).
The 8 mm gas line is connected to the connection nozzle with
a cutting ring connection. The cutting rings provided are to be
selected according to the gas pipe used (for copper pipe, sup-
port sleeve and brass cutting ring). When tightening, hold in
position carefully with a second spanner!
Before connecting to the water heater make sure that the gas
lines are free from dirt, chips and such!
Route the pipes in such a way that the appliance can be re-
moved again for servicing.
In areas frequented by people, keep the number of par ting
connections in the gas supply line to an technically feasible
minimum.
The gas system must accord with the technical and adminis-
trative provisions of the individual country of use (in Europe,
for example, EN 1949 for motor vehicles or EN ISO 10239 for
boats). The national regulations and directives (e.g. in Germa-
ny the DVGW-Work Sheet G 607 for vehicles, G 608 for boats
or BGV 146 for commercial inland waterway vessels) need to
be observed.
Function check
After installation, the gas feed line must be tested for tight-
ness by the pressure-drop method. A test certificate (e.g. in
Germany the DVGW-Work Sheet G 607 for vehicles, G 608 for
boats or BGV 146 for commercial inland waterway vessels)
must be issued.
Never operate the water heater without water contents!
It is, however, possible to briefly check the electrical function
without water contents. Always observe the operating instruc-
tions prior to operation!
Warning information
The yellow sticker with the warning information enclosed with
this unit must be attached by the person installing the boat
or the owner of the boat / vehicle in a place within the vehicle
that is clearly visible to all users (e.g. on the wardrobe door)!
Any missing stickers can be ordered from Truma. Ask Truma
to send you stickers, if necessary.
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Truma BM 14 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Truma BM 14 in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info