Manual Truma Aventa comfort (page 16 of 80) (English, German, Dutch, Danish, French, Italian, Spanish)

489376

Zoom out

Zoom in

1/80

Taking into operation

Before switching on, it is essential to make sure that the fuse

system for the power supply at the camp site is sufficient

(230 V).

In order to prevent the power cable for the caravan from

overheating (minimum cross-section 3 x 2.5 mm²) the

cable drum must be fully unwound.

To carry out the individual switching commands, the remote

control must always be pointed at the infrared receiver.

Switching on

Press the “On / Off switch” on the remote control to switch

on the air conditioning unit. The most recent settings are

applied.

After switching on, the air circulation fan starts to run.

The compressor activates after a maximum of 3 minutes,

and the blue (cooling) / yellow (heating) LED flashes.

Temperature

If required, adjust the room temperature setting using the “+”

and “–” “Temperature selection buttons”.

Mode

Select the required operating mode by pressing the “MODE”

button one or more times.

Cooling

Heating

Automatic (heating or cooling mode depending on the room

temperature setting)

Circulated air

When the room temperature that was selected using the

remote remote control is reached in cooling mode, the com-

pressor switches off and the blue LED in the IR receiver goes

out. The air circulation fan continues to run in order to provide

ventilation. If the room temperature setting is exceeded, the

device automatically reverts to cooling mode.

The air is dehumidified during the cooling process. If the

atmospheric humidity is extremely high in the vehicle

when the cooling process starts, moisture can form on the un-

derside of the air distributor. The doors and windows should

therefore be kept closed and the highest fan setting selected.

When the room temperature that was selected using the re-

mote control is reached in heating mode, the compressor

switches off and the yellow LED in the IR receiver goes out.

The air circulation fan continues to run in order to provide ven-

tilation. If the temperature drops below the room temperature

setting, the device automatically reverts to heating mode.

Heating is not possible at an outside temperature of

less than 4 °C, as the heating power drops significantly.

Between 4 °C and 7 °C the device briefly switches to thawing

processes. Heating is possible without restrictions above 7 °C.

Cooling/heating mode and the fan level are selected automati-

cally depending on the room temperature when the unit is in

automatic mode.

In recirculated air mode, the interior air is circulated and

cleaned by the filters. No LED‘s illuminate on the IR receiver.

–

Fan

Select the required fan level by pressing the “Fan level” but-

ton one or more times.

Fan level (not operational in automatic mode)

Low

Medium (not heating mode)

High

Sleep function

When the “Sleep function” is active (cooling mode only),

the interior fan and the exterior fan operate at slow speed

and therefore extremely quietly.

Switching off

Press the “On / Off” button on the remote control to switch

the equipment off. The remote control and the unit are

switched off. The light can still be operated using the

“Ambient lighting” button.

If the air conditioning unit is switched on again, the blue /

yellow LED flashes. The air circulation fan runs and the

compressor switches itself on after a maximum of 3 minutes.

Time

Press the “Time selection button” and set the current time

using the “Time setting” buttons.

The time is always shown in the display (except with Timer

ON / OFF).

The time must be reset after a battery change or daylight sav-

ing time change.

Timer ON / OFF

The air conditioning unit on / off time can be set in advance

from a minimum of 15 minutes up to a maximum 24 hours,

starting from the current time.

To carry out programming, switch on the unit with the remote

control.

Set the required operating mode and room temperature.

Then select TIMER ON or TIMER OFF using the “TIMER

selection buttons”. Set the required on / off time using the

“Time setting” buttons (15 minutes – 24 hours) and confirm

with TIMER ON or TIMER OFF.

Press the relevant timer button again to deactivate the timer

function.

Ambient lighting

Independently of the operation of the air conditioning system,

the lighting in the air distributor can be switched on and off

by pressing the „Ambient lighting“ button. To dim the light-

ing, press and hold down the “Ambient lighting” button.

Press the button again to activate or deactivate the lighting.

When the lighting is switched on again, the previous setting is

activated.

Reset

The settings on the remote control are reset to “AUTO, 22 °C,

12:00, No timer, No light”.

Resend

The most recent settings are transmitted again.

–

Truma aventa making clicking noise. Other than the noise, which gets louder with use, the unit works perfectly. Has anyone else had this problem?
Bev Submitted on 7-4-2023 at 08:16
Reply Report abuse
My truma aventa is making a ticking noise. Has got a solution due this problem. The unit works perfectly otherwise Submitted on 7-4-2023 at 08:13
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Truma Aventa comfort in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 3,67 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Truma Aventa comfort Manual

Product: