753360
12
Zoom out
Zoom in
Previous page
1/17
Next page
12 EN
cordless tacker PTNS 10-20V
Impact force preselection
The impact force can be adjusted according to the material by
using the impact force regulator(16). If the impact force is set
too high, there is a risk that the material to be attached will be
pierced. If the impact force is set too low, the staples cannot
penetrate the material deeply enough and will not be attached
properly.
The required impact force depends on the material and can be
determined by way of field-testing. To do this, ideally use some
excess material residues. Always use the lowest impact force
required for entirely injecting the staple.
The setting range is between stages1– 6. Stage1 refers to the
lowest impact force, stage6 to the highest. You can change the
impact force which you have preselected at any time.
1. Turn the regulator(16) to the desired stage.
16
Operation
Tips and notes on handling the tacker
Warning of sharp object
Wire nails and staples are sharp. Risk of injuries if
handled without due care!
General information:
Always apply the device to the workpiece firmly and at a
right angle. Otherwise the staple or wire nail could be
diverted sideways.
Be careful when using the device on soft workpieces. Else
the workpiece could be damaged.
Observe the size of staples and wire nails as specified in
the technical data.
At the magazine filling level indicator you can check
whether any staples or wire nails are left in the magazine.
Always remove the battery from the device when a staple
or wire nail is jammed inside! The trigger could be
actuated by accident while removing a jammed staple or
wire nail.
The trigger(2) is linked to the movable tacker guide
nose(5) and will only trigger if the tacker guide nose is
pushed on the workpiece. It makes sure that a shot cannot
be released accidentally just by inadvertently pulling the
trigger.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trotec PTNS10-20V at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trotec PTNS10-20V in the language / languages: English as an attachment in your email.

The manual is 2,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Trotec PTNS10-20V

Trotec PTNS10-20V User Manual - German - 18 pages

Trotec PTNS10-20V User Manual - Dutch - 17 pages

Trotec PTNS10-20V User Manual - French - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info