753272
10
Zoom out
Zoom in
Previous page
1/18
Next page
10 EN
cordless drill driver PSCS 11-20V
Charging the battery
Note
The battery can be damaged in case of improper
charging.
Remove the charger's mains plug before inserting or
removing the battery.
Never charge the battery at ambient temperatures
below 10°C or above 40°C.
The battery is partially charged upon delivery to avoid damage
to the battery caused by a deep discharge.
Prior to initial start-up and when the battery is low (only the red
LED in the battery level indication(14) is illuminated), the
battery should be charged. To do so, please proceed as follows:
1. Slide the battery(8) onto the quick charger(9) upside
down until it locks in place.
13
10
1 h
9
8
2. Insert the mains plug of the quick charger(9) into a
properly fused mains socket.
ðThe red battery LED(10) lights up.
ðCharging requires approx. one hour.
3. Wait until the red battery LED(10) goes off and the green
battery LED(13) lights up.
ðThe battery(8) is fully charged.
4. Hold onto the mains plug while pulling the power cable of
the quick charger(9) out of the mains socket.
ðThe battery(8) and the quick charger(9) may have
become warm during charging.
Allow the battery(8) to cool down to room temperature.
5. Take the battery(8) out of the quick charger(9) by
pressing and holding the release button(15) and pulling
the battery(8) off the quick charger(9).
Inserting the battery
1. Set the switch for clockwise/ counter-clockwise
rotation(4) to centre position(lock).
2. Slide the battery(8) onto the device until it locks in place.
4
8
Removing the battery
1. Set the switch for clockwise/ counter-clockwise
rotation(4) to centre position(lock).
2. Detach the battery(8) from the device by pressing and
holding the unlocking button(15, I.) and pulling the battery
off the device(II.).
I.
II.
4
8
15
3. If required, charge the battery(8) as described in the
section Charging the battery.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trotec PSCS11-20V at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trotec PSCS11-20V in the language / languages: English as an attachment in your email.

The manual is 2,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Trotec PSCS11-20V

Trotec PSCS11-20V User Manual - German - 19 pages

Trotec PSCS11-20V User Manual - Dutch - 19 pages

Trotec PSCS11-20V User Manual - French - 19 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info