795072
6
Zoom out
Zoom in
Previous page
1/17
Next page
6 EN
humidifier B 3 E / B 4 E
Storage
Before storing the device, proceed as follows:
Hold onto the mains plug while pulling the power cable out
of the mains socket.
Empty the water tank.
Empty the lower part.
Use a cloth to wipe all parts of the device dry.
Clean the device according to the Maintenance chapter.
When the device is not being used, observe the following
storage conditions:
Store the device in a dry location and protected from frost
and heat.
Store the device in an upright position where it is protected
from dust and direct sunlight.
If required, use a cover to protect the device from invasive
dust.
Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and installation
Scope of delivery
1x Device
1x Adapter
1x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
Only put up the device in an upright, stable position on firm
ground.
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
Make sure that extension cables are completely unrolled.
Make sure that there are no moisture-sensitive objects in
the immediate vicinity of the mist nozzle, since water may
condense near the mist nozzle.
Observe the following before operating the device after a period
of non-use or after the device has been stored:
Clean the housing and the water tank prior to
recommissioning (see chapter Maintenance).
Filling the water tank
The water tank(4) should be filled with clear drinking water
before first use.
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket!
Do not touch the mains plug with wet or damp hands.
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Note
Fill the device with clear drinking water only. The water
temperature must not exceed40°C.
Scented oil or other additives can damage the plastics
and the nebulizer membrane.
Info
If possible, change the water every3days to prevent
bacterial growth.
Info
The low water level LED(20) flashes permanently
when the water level in the water tank(4) is too low.
Info
The low water level LED(20) flashes three times in
succession when the water tank(4) is empty. The dry-
run protection is activated.
1. Open the lid with air outlet(1).
1
4
2. Fill clear drinking water(maximally40°C) up to the MAX
indication into the water tank(4).
3. Insert the SecoSan® Stick (optional accessory)(15) into the
water tank(4).
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trotec B4E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trotec B4E in the language / languages: English as an attachment in your email.

The manual is 4.45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info