689442
7
Zoom out
Zoom in
Previous page
1/12
Next page
EN 7
air washer AW 20 S
Setting the fan stage
The following table shows an overview of the fan stages:
Operating
mode
Description Indication
Auto Fan speed control depending on room
humidity.
When reaching a humidity level of
50%, the device stops. It continues
to operate as soon as the measured
humidity level falls below 50%.
Night mode The device runs in night mode. The
LED illumination of the control panel
is dimmed. The fan runs at the lowest
speed.
When reaching a humidity level of
50%, the device stops. It continues
to operate as soon as the measured
humidity level falls below 50%.
Fan max The fan runs at the highest speed,
regardless of the room humidity.
Fan med The fan runs at medium speed,
regardless of the room humidity.
Fan min The fan runs at the lowest speed,
regardless of the room humidity.
1. Press the fan stage selection button(20) until the desired
fan stage is set.
ð The corresponding indication is illuminated.
Switching the plasma generator on or off
The plasma generator can be switched on or off as needed.
1. Press the plasma generator button(30) to switch the
plasma generator on or off.
ð If the plasma generator is switched on, the plasma
generator indication(29) is illuminated.
ð If the plasma generator is switched off, the illuminated
plasma generator indication(29) goes out.
Adding water
If the water tank indication(17) is illuminated, you have to refill
water.
Note:
After approx. one week of operation, the water tank should be
cleaned before refilling with fresh drinking water. Further
information on cleaning the water tank can be found in the
chapter Maintenance.
1. Press the power button(13).
ð The device switches off.
2. Remove the mains plug from the mains socket.
3. Remove the upper part from the water tank.
4. Fill the water tank with fresh drinking water.
ð The filling level should be below the filling level line in
the water tank.
5. Check whether the (optional) SecoSan
®
stick is correctly
positioned inside the water tank.
6. Place the upper part onto the water tank.
ð The display on the upper part and the logo on the lower
part should point in the same direction.
7. Check whether the upper and lower part are properly
interconnected as otherwise the device cannot be
switched on.
8. Plug the mains plug into a sufficiently fused mains socket.
9. Press the power button(13).
ð The device switches back on.
Shutdown
Hold onto the mains plug while pulling the power cable out
of the mains socket.
Empty and clean the water tank.
Remove the SecoSan
®
stick, if necessary.
Clean the upper louvres according to the Maintenance
chapter.
Store the device according to the Storage chapter.
Available accessories
Designation Article number
SecoSan
®
Stick10 6.100.004.110
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trotec AW20S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trotec AW20S in the language / languages: English as an attachment in your email.

The manual is 7,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Trotec AW20S

Trotec AW20S User Manual - German - 12 pages

Trotec AW20S User Manual - Dutch - 14 pages

Trotec AW20S User Manual - French - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info