576539
8
Zoom out
Zoom in
Previous page
1/60
Next page
10 GB/IE/CY
Operation
This avoids sparking, which often occurs when con-
necting. Furthermore, this device is also controlled
by an internal MCU (Micro-Computer-Unit), which
makes it faster, more powerful and more reliable.
Q
Reset / deleting settings
After connection to the power supply, the appliance
automatically returns to its basic setting and remains
in STANDBY mode
Q
Switching over between
modes 1, 2 and 3
j Press the selection button MODE
8
repeatedly
to display the charging modes in the following
order: Ready STANDBY, MODE1
, MODE2
, MODE3
and start the next cycle.
If you press the selector button
8
,charging mode
automatically switches over to the next mode and
begins operation in that mode. However, if a battery
is not disconnected from the charging station after
a full charge, the appliance remains in trickle-charge
mode, even if the user switches over to another mode.
This protects the battery from being damaged.
Q
Mode 1 (14.4 V / 0.8 A)
This mode is suitable for charging small batteries
with a capacity below 14 Ah.
j Press the selection button MODE
8
, to select
mode 1. After doing so, the corresponding LED
display
2
lights up. If you do not activate
an-other process afterwards, the electronic sys-
tem will automatically start the charging process
together with the LED display
7
at (with a
current of) 0.8 A ± 10 %.
If the procedure runs without any problems, the
LED display
7
remains on during the entire
charging process, until the battery is fully charged
at 14.4 V / ± 0.25 V. When the battery is fully
charged, LED display
6
lights up and LED
display
7
goes out. The floating current is now
available for the battery.
Q
Mode 2 (14.4 V / 3.6 A)
This mode is mainly used for charging batteries with
a large capacity exceeding 14 Ah under normal
conditions.
j Press the selection button MODE
8
, to activate
mode 2. If you do not activate another process
afterwards, the electronic system, together with
LED display
3
starts the charging process
at (with a current of) 3.6 A ± 10 % (3.6 A).
If the procedure runs without any problems, the
LED display
7
remains on during the entire
charging process, until the battery is fully charged
at 14.4 V / ± 0.25 V. When the battery is fully
charged, LED display
6
lights up and LED
display
7
goes out. The floating current is
now available for the battery.
Q
Mode 3 (14.7 V / 3.6 A)
This mode is used for charging batteries with a
greater capacity than 14 Ah in cold conditions or
for several AGM batteries with more than 14 Ah.
j Press the selection button MODE
8
, to activate
mode 3. As soon as you have selected the suit-
able charging mode, the corresponding LED
display
4
lights up immeditely. If you do not
take any further action, the electronic system
starts the charging process with a set delay. In
this mode the charging current is identical to
that of „Mode 2“.
If the procedure runs without any problems, the
LED display
7
lights up, the electronic stys-
tem is active and remains in this condition until
the battery is charged to approx. 14.7 V. As
soon as this is reached, the charging station
switches over to trickle-charging function. Now
LED display
7
goes out and LED display
6
lights up to indicate the current status.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tronic KH 3157 - T4X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tronic KH 3157 - T4X in the language / languages: English, German, Danish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 1,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Tronic KH 3157 - T4X

Tronic KH 3157 - T4X User Manual - German, Dutch, French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info