457531
9
Zoom out
Zoom in
Previous page
1/84
Next page
16
Twins needle
Take out the single needle, then put the twins needle. Put two bobbins onto the winding thread
guide, same as picture below. Two stitches separately insert into two pinpole of twins needle.
Other steps are same as threading the single needle.
Note: Twins needle is only suitable for straight stitch. It can sew two straight stitches in parallel.
1 2
Upper thread.
For quick and easy installation of the upper thread follow the steps below.
The open line in the picture below, suggests the thread which goes through the device.
The enlargements can be a clarification of the step.
1. Put the bobbin on the bobbin winder and guide the thread over the winding thread
guide from right to left.
Push thread tension release bar (A) to left, then guide the thread down between the
tension disc making sure that the thread has been inserted into the tension disc.
2. Continue to draw the thread down and around the thread pulling bar fixed holder
spring (B) from left to right.
3. Draw the thread up, through the take-up lever draw (C) from left to right.
4. Continue to draw the thread down through the upper guide (D) from front to back.
5. Drawing down the thread and through the lower guide from back to front.
6. Continue to draw down the thread through the thread protector (E).
7. Finally thread the needle from front to back (important !!!!)
17
C
A
B
D
E
Lower thread
When inserting or removing the lower bobbin, the needle must be fully raised.
Turn the hand wheel (no.11). Pull out the plastic transparent cover (no. 9).
Insert the bobbin in the bobbin case, so that the thread rund in a clockwise direction.
Replace the transparent cover (no. 9)
Raise the presser foot, hold the upper thread with the left hand, right hand turn the handwheel
anticlockwise until the needle is raised. When the needle reach the bottom, the hook tray will
hook the upper thread, rotate the hook tray to pull the lower thread out. Pull the lower and
upper thread under presser foot(no.8), pull out 10 cm to the back.
No.11
No.14
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tristar SM 6000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tristar SM 6000 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info