483971

Tristar KB-7147 Manual

12
Zoom out
Zoom in
Previous page
1/25
Next page
V10.01 22
Connection of the refrigerator to the cylinder of liquefied petroleum gas
CAUTION: always stay clear of any source ignition during this operation. Do not smoke.
Connect the COOLBOX in the following order:
Gas cylinder > pressure regulator > appliance
The gas connection tube at the rear of the appliance is designed for a standard NF XPD
36 110 butane / propane flexible hose. It is essential to follow the assembly and
connection instructions for the appliance to be connected. Excessive twisting and
bending are to be avoided. Bends in the gas hose must have a radius of more than 40
mm. The length of the hose must not exceed 1.50 m.
If you wish to check for leaks, please use soapy water, do not use a flame.
It is prohibited to check for leaks with a flame.
Do not smoke: danger of explosion and burns.
When changing the gas cylinder and/or disconnecting the hose, it is mandatory to close
the valve of the gas cylinder.
Replace the hose if it is damaged or if it becomes porous and in any case before the
expiry date printed on the side.
Gas valve assembly
This assembly consists of an adjusting device with an incorporated safety pilot, a burner
with an electric igniter.
The adjusting device can be set to 3 different positions:
Maximum cooling
Minimum cooling
0 off
Igniting position / burner gas supply closed
The safety pilot automatically maintains the gas supply to the burner, as long as it
remains lit. It automatically shuts off the supply if the flame goes out.
V10.01 23
Ignition of the liquefied petroleum gas burner
Open the valve of the gas cylinder.
Press the adjusting knob and hold it in this position, then turn the knob anti-clockwise to
Max. If the appliance has not been ignited for a long period, or if the gas cylinder has
been changed, there may be some air in the duct, so it may fail to be ignited. It is
necessary to check that the pilot is lit by looking through the orifice at the top of the
appliance. If the appliance fails to be ignited, try it again after approximate 10 seconds.
When the outside temperature is low, set the adjusting device to MIN after a sufficient
long cool-down period in MAX position.
To disconnect an appliance running on gas Far from any source of ignition
Shut off the gas cylinder or the pressure regulator.
Turn the knob to the OFF position.
Storing food
Liquids to be stored in the refrigerator shall always be placed in a closed vessel.
The air circulation inside the appliance must not be obstructed.
Never place hot food or drink in the appliance.
Never keep flammable liquids and/or gases inside the refrigerator. Danger of
explosion.
Defrosting – Measures to be taken if the appliance is to be left unused for a long
period
The refrigerator must be defrosted regularly, in order to ensure that it operates
correctly.
To defrost the refrigerator, disconnect it and remove all food outside. If necessary, use a
cloth soaked with hot water. After de-icing, mop up the water with a dry clean cloth and
clean the inside as described in paragraph 13.
If the appliance is to remain unused for a extensive period, disconnect it and remove all
food outside. After de-icing, clean and dry the inside of the appliance.
In order to prevent unpleasant odor, leave the cover of the refrigerator slightly open.
Measures to be taken after unused for a long period
If, after an extensive lay-up period, the refrigerator does not produce any cooling,
disconnect the appliance and turn it upside down for a few minutes then turn it the right
way up. After turn it over several times, reconnect it.
Maintenance
Clean the appliance regularly with warm water, containing a detergent if necessary.
Never use an abrasive product. Dry the cleaned surfaces with a soft cloth. Use only clear
water to clean the seal of the cover, and then coat the seal with talcum powder.
All repairs, particularly of the cooling unit or the gas burner system, must mandatorily be
carried out by a qualified technician.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tristar KB-7147 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tristar KB-7147 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info