483971
11
Zoom out
Zoom in
Previous page
1/25
Next page
V10.01 20
Installation of the appliance
Install the appliance on a firm, horizontal surface. To level the appliance, use a spirit
level or a vessel containing water, if necessary. If you want ice, place the tray filled with
water on the cooling element.
Avoid installing the appliance in direct sunlight or near any source of heat.
The distance between the rear of the appliance and a wall shall not be less than 10 cm,
and the minimum ventilating space from the sides of the appliance shall never be less
than 5 cm.
In all cases, the location shall be protected from rain and splashing.
To guarantee a good level of air circulation, do not obstruct the ventilation grids of the
upper, lower or rear surface of the appliance.
Complying with the above will ensure efficient an economical cooling.
Before the first use of the appliance, clean the inside and the cover of the appliance with
warm water, adding detergent if necessary. Never use an abrasive product.
Operation with the mains
Never use another source of energy at the same time (battery, liquefied petroleum gas).
Check that the mains voltage corresponds to the operating voltage specified on the label
(on the rear of the appliance).
If the electrical specifications are correct, push the safety electrical plug into an earthed
wall socket which is wired according to the specifications.
Start-up
Turn the thermostat knob clockwise to the MAX position. The effects of the cooling
process (frost on the evaporator) only become visible after about an hour.
The thermostat enables the temperature of the refrigerator to be adjustable
(“0”=cooling process stopped).
After a sufficient cooling period (approximately 5 hours), the thermostat can be set to an
intermediate position. The selected temperature is regulated automatically by the
thermostat.
Shut-down
Turn the thermostat knob anti-clockwise to the “0” position.
Remove the plug from the wall outlet.
Operation with a battery (12V or 24V DC)
Do not use another source of energy at the same time (mains, liquefied petroleum gas).
A safety fuse must be installed in the power supply line between the battery and the
refrigerator.
V10.01 21
For 12V, the maximum fuse rating is 6.25 amps. For 24V, the maximum fuse rating is
3.12 amps.
Max. cable length
Cable cross
-
section
12V DC
24V DC
2.5mm
2
2.5m
5m
4.0mm
2
4
.0m
8m
6.0mm
2
6.0m
It is not necessary to check the polarity when starting up the appliance.
Check that the battery voltage corresponds to the operating voltage of the refrigerator,
as marked on the corresponding the label. When the battery used is a car battery, only
switch the refrigerator on while the car is traveling. If the refrigerator is left running
when the car is stopped, this could discharge the battery and it may be impossible to
restart the engine. When the appliance is running on the battery, there is no
thermostat-controlled temperature regulation.
Recommendation
Pre-cool the refrigerator by running it on the mains, before starting the journey.
Start-up
Plug the connector supplied with the refrigerator into the cigar lighter socket of the
vehicle.
Disconnection of the appliance
Unplug the connector from the cigar lighter socket.
Operation with liquefied petroleum gas
Operation of the refrigerator on liquefied petroleum gas is prohibited in road vehicles
and on boats.
Operation using liquefied petroleum gas is prohibited in closed areas.
This appliance must be in the open air when operating with liquefied petroleum gas.
Operation in the open air means that the appliance can also be installed under the
canopy of a tent, sufficiently ventilated, or on a terrace in a flat and level garden.
Do not use another source of energy at the same time (mains, battery). The label at the
rear of the appliance gives the recommended gas supply pressure expressed in milibars.
The appliance can not operate at a pressure other than the one specified on the label. It
is recommended to use an appropriate pressure regulator (butane 28-30 mbars or
propane 37 mbars).
Storage of gas cylinders
Store the gas cylinder in a cool, dry and ventilated area, protected from sunlight and do
not exposed to temperatures above 50°C.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tristar KB-7147 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tristar KB-7147 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info