548204
22
Zoom out
Zoom in
Previous page
1/41
Next page


To adjust the height of the adjustable-rise stem
in Figure 12, rst change the stem angle, which
gives access to the stem expander bolt.
1. Loosen the
stem expander
bolt two to
three turns.
2. Tap the top
of the stem
expander bolt
with a wood
or plastic-
faced mallet to
loosen the stem
wedge.
3. Adjust the
handlebar to
the desired
height, but
with the
minimum
insertion
line inside
the frame
(Figure 13). A
minimum of
2
3/4
(70 mm)
of the stem
quill must
always remain
in the frame.
4. Tighten to
120 lb•in (13.6 N•m).


1. Loosen the angle adjustment
bolt (Figure 12) until the stem
angle can be changed.
2. Position the stem to the desired
angle.
3. Tighten the angle adjusting
bolt to 150-170 lb•in (17-20.3
N•m).


1. Slide the
locking button
(Figure 14)
forward and
lift the quick-
release lever.
2. Position the
stem and
handlebar to
the desired
angle.
3. Close the
quick-release
lever.
Make sure the
lever is completely closed and the
locking button has returned to its
locked position.



1. Open the quick-release lever.
2. Turn the tension adjusting
screw (Figure 14).
3. Check that at about halfway
through the lever throw there is
some resistance.
If the clamp force is too high or too low, re-
adjust the screw.
Chapter : Adjustment









Figure - Adjustable-rise
quill stem
A- Handlebar clamp
bolts
B- Stem expander bolt
C- Angle adjusting bolt
B
C
A
Figure - Minimum
insertion mark on quill
stem
A- This line must be
inside the bike frame
A
Figure - Bontrager
adjustable-rise stem
A- Tension adjusting
screw
B- Quick-release lever
C- Locking button
B
C
A
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trek 07-TK at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trek 07-TK in the language / languages: English as an attachment in your email.

The manual is 5,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info